User Manual (XP)
37
Intentional emitter per FCC Part 15
(If tted with 2.4G band or 5G band) 
Low power, Radio LAN type devices 
(radio frequency (RF) wireless 
communication devices), operating in 
the 2.4GHz/5GHz Band, may be present 
(embedded) in your notebook system. 
This section is only applicable if these 
devices are present. Refer to the system 
label to verify the presence of wireless 
devices.
Wireless devices that may be in your 
system are only qualied for use in the 
United States of America if an FCC ID 
number is on the system label.
This device is restricted to indoor use 
due to its operation in the 5.15 to 5.25 
GHz frequency range. FCC requires 
this product to be used indoors for 
the frequency range 5.15 to 5.25 GHz 
to reduce the potential for harmful 
interference to co-channel Mobile Satellite 
systems. High power radars are allocated 
as primary users of the 5.25 to 5.35 GHz 
and 5.65 to 5.85 GHz bands. These radar 
stations can cause interference with and 
/or damage this device.
The power output of the wireless device 
(or devices), which may be embedded 
in your notebook, is well below the RF 
exposure limits as set by the FCC.
This transmitter must not be collocated 
or operate in conjunction with any other 
antenna or transmitter except the installed 
Bluetooth transmitter.
Operation of this device is subject to the 
following two conditions: (1) This device 
may not cause harmful interference, 
and (2) this device must accept any 
interference received, including 
interference that may cause undesired 
operation of the device.
Wireless devices are not user 
serviceable. Do not modify them in 
any way. 
Modication to a wireless device 
will void the authorization to use it. 
Contact manufacturer for service.
FCC Part 68 
(If tted with a modem device.)
This equipment compiles with part 
of the FCC rules. On the back of this 
equipment is a label that contains, among 
other information, the FCC registration 
number and ringer equivalence number 
(REN) for this equipment. If requested, 
this information must be provided to the 
telephone company.
This equipment uses the following USOC 
jacks : RJ11C










