User Manual (XP/Windows7)

40
Intentional Emitter per RSS 210
(If tted with 2.4G band or 5G band)
Low power, Radio LAN type devices
(radio frequency (RF) wireless
communication devices), operating in
the 2.4GHz/5GHz Band, may be present
(embedded) in your notebook system.
This section is only applicable if these
devices are present. Refer to the system
label to verify the presence of wireless
devices.
Wireless devices that may be in your
system are only qualied for use in
Canada if an Industry Canada ID number
is on the system label.
When using IEEE 802.11a wireless LAN,
this product is restricted to indoor use
due to its operation in the 5.15- to 5.25-
GHz frequency range. Industry Canada
requires this product to be used indoors
for the frequency range of 5.15 GHz to
5.25 GHz to reduce the potential for
harmful interference to co-channel mobile
satellite systems. High power radar is
allocated as the primary user of the
5.25- to 5.35-GHz and 5.65 to 5.85-GHz
bands. These radar stations can cause
interference with and/or damage to this
device.
The maximum allowed antenna gain for
use with this device is 6dBi in order to
comply with the E.I.R.P limit for the 5.25-
to 5.35 and 5.725 to 5.85 GHz frequency
range in point-to-point operation.
The power output of the wireless device
(or devices), which may be embedded
in your notebook, is well below the
RF exposure limits as set by Industry
Canada.
Operation of this device is subject to the
following two conditions: (1) This device
may not cause harmful interference,
and (2) this device must accept any
interference received, including
interference that may cause undesired
operation of the device.
To prevent radio interference to
licensed service, this device is
intended to be operated indoors
and away from windows to provide
maximum shielding. Equipment (or
its transmit antenna) that is installed
outdoors is subject to licensing.
Wireless devices are not user
serviceable. Do not modify them in
any way. Modication to a wireless
device will void the authorization
to use it. Contact manufacturer for
service.