User Manual (XP/Windows7)

109
Upgrading Memory
A memory is installed in the memory slot at the bottom of this computer. The
procedures to replace the memory are described below.
 Replace new memory only after shutting the computer down completely. Do not
replace memory when the computer is in Sleep mode.
 Disconnect main power plug and remove the battery before continuing.
OnlyusethesametypeofmemoryasspeciedintheProductSpecication.
Thememorycompartmentcovermaydifferfromthegurebelow.
 You must use only memory modules
withthespecications(DDR2or
DDR3) printed on the memory slot that
appears when you open the memory
compartment cover at the bottom.
e.g)inthecaseofusingDDR2
Replacing the Memory
1
Remove the screw on the memory
compartment cover at the bottom of
the computer using a screw driver.
Fixing Screw
2
 Pullthememorymodulelatches
outward. The memory module will pop
up.
Remove the memory module out at
an angle of 30 degrees.