User Manual
Table Of Contents
- Important safety instructions
- What you need to know about safety instructions
- California Proposition 65 Warning
- For your safety
- Induction cooktop elements
- Electrical Safety
- Child safety
- Oven
- Remote Operation
- Self-cleaning ovens
- Ventilating hood
- Glass/Ceramic cooking surfaces
- Critical installation warnings
- Critical usage warning
- Usage cautions
- Critical cleaning warnings
- Introducing your new range
- Before you begin
- Surface cooking
- About induction cooktop cooking
- How to set the appliance for cooktop cooking
- Before using the cooktop
- Cookware for induction cooking zones
- Using the correct size cookware
- Pot and pan sizes
- Induction cookware test
- Operating noises
- Using suitable induction cookware
- Temperature detection
- Suggested settings for cooking specific foods
- Protecting the cooktop
- Operating the oven
- The oven control panel
- Oven lock
- Setting the clock
- Setting the kitchen timer
- Timed cooking
- Delay start
- Turning the oven light on and off
- Minimum and maximum settings
- Using the oven racks
- Baking
- Broiling
- Using the special fuction
- Using the keep warm feature
- Using the smart control feature
- Using the voice control
- Using the options function
- Using the Sabbath feature
- Maintaining your appliance
- Troubleshooting
- Warranty (U.S.A)
- Warranty (CANADA)
- Appendix
50 English
Maintaining your appliance
Maintaining your appliance
Fig. 2Fig. 2
5. Lift door up and out until the hinge arm
is clear of the slot (Fig. 2).
How to re-install the door
Hinge armHinge arm
Bottom Bottom
edge of edge of
slotslot
IndentationIndentation
1. Firmly grasp both sides of the door at the top.
2. With the door at the same angle as the removal position, slide the indentation
of the hinge arm into the bottom edge of the hinge slot. The notch in the
hinge arm must be fully inserted into the bottom of the slot.
Removing and reinstalling the oven door
How to remove the door
CAUTION
• The door is very heavy. Be careful when removing and lifting the door.
Do not lift the door by the handle.
• Turn the power OFF before removing the door.
Hinge lockHinge lock
Locked positionLocked position
Unlocked positionUnlocked position
1. Open the door completely.
2. Pull the hinge locks down toward the door frame to the unlocked position.
about 5 °about 5 °
Fig. 1Fig. 1
3. Firmly grasp both sides of the door at
the top.
4. Close the door to the door removal
position, which is approximately
5 degrees from vertical (Fig. 1).