User Manual
Table Of Contents
- Important safety instructions
- What you need to know about safety instructions
- California Proposition 65 Warning
- For your safety
- Induction cooktop elements
- Electrical Safety
- Child safety
- Oven
- Remote Operation
- Self-cleaning ovens
- Ventilating hood
- Glass/Ceramic cooking surfaces
- Critical installation warnings
- Critical usage warning
- Usage cautions
- Critical cleaning warnings
- Introducing your new range
- Before you begin
- Surface cooking
- About induction cooktop cooking
- How to set the appliance for cooktop cooking
- Before using the cooktop
- Cookware for induction cooking zones
- Using the correct size cookware
- Pot and pan sizes
- Induction cookware test
- Operating noises
- Using suitable induction cookware
- Temperature detection
- Suggested settings for cooking specific foods
- Protecting the cooktop
- Operating the oven
- The oven control panel
- Oven lock
- Setting the clock
- Setting the kitchen timer
- Timed cooking
- Delay start
- Turning the oven light on and off
- Minimum and maximum settings
- Using the oven racks
- Baking
- Broiling
- Using the special fuction
- Using the keep warm feature
- Using the smart control feature
- Using the voice control
- Using the options function
- Using the Sabbath feature
- Maintaining your appliance
- Troubleshooting
- Warranty (U.S.A)
- Warranty (CANADA)
- Appendix
English 45
Maintaining your appliance
Steam-cleaning
How to set the oven for steam-cleaning
For light cleaning, the steam-cleaning function saves time and energy. For heavier-
duty cleaning, use the self-cleaning function.
1. Remove all accessories from the oven.
2. Pour approximately 10 oz. (300 ml) of
water onto the bottom of the empty
oven and then close the oven door.
Use normal water only, not distilled
water.
3. Press Steam Clean.
4. Press START/SET.
When the operation is complete, the
display will blink and a beep will sound.
5. Press OFF/CLEAR.
6. Clean the oven’s interior.
There will be a signicant amount of
water remaining on the bottom of the
oven after a steam-cleaning cycle.
Remove the residual water with a
sponge or soft dry cloth.
NOTE
When steam-cleaning, use exactly 10 oz. of water since this produces the best
results.
NOTE
If you press Steam Clean when the oven temperature is above 100˚F, Hot will
appear in the display. Because this function produces the best results when started
while the oven is cool, we recommend that you wait until the oven has cooled
down and Hot disappears from the display.
CAUTION
Wear the glove during cleaning.
After a steam-cleaning cycle
• Take care when opening the door before a steam-cleaning procedure has
ended. The water on the bottom is hot.
• Open the oven door and remove the remaining water with a sponge. Do not
leave the residual water in the oven for any length of time. Wipe the oven
clean and dry with a soft cloth. Do not forget to wipe under the oven door
seal.
• Use a detergent-soaked sponge, a soft brush, or a nylon scrubber to wipe the
oven interior. Remove stubborn residue with a nylon scourer. You can remove
lime deposits with a cloth soaked in vinegar.
• If the oven remains dirty, you can repeat the procedure once the oven has
cooled.
• For heavy residue, such as grease left over from roasting, we recommend
that you rub detergent into the residue before activating the steam-cleaning
function.
• After cleaning, leave the oven door ajar at a 15° angle to allow the interior
enamel surface to dry thoroughly.