Datasheet

- 26 -
MMCRE64G5MXP-0VB datasheet SSD
Rev. 1.3
MMCRE28G5MXP-0VB
MMDOE56G5MXP-0VB
7.3.2.10 Error logging capability
Bit Definition
7-1 Reserved (0)
0 The Error Logging support bit. If bit = 1, the device supports the Error Logging
7.3.2.11 Self-test failure check point
This byte indicates the section of self-test where the device detected a failure.
7.3.2.12 Self-test completion time
These bytes are the minimum time in minutes to complete the self-test.
7.3.2.13 Data Structure Checksum
The Data Structure Checksum is the 2's compliment of the result of a simple 8-bit addition of the first 511 bytes in the data structure.
7.3.3 1 Device Attribute Thresholds data structure
The following defines the 512 bytes that make up the Attribute Threshold information. This data structure is accessed by the host in its entirety using the
S.M.A.R.T. Read Attribute Thresholds. All multibyte fields shown in these data structures follow the ATA/ATAPI-6 specification for byte ordering, that is,
that the least significant byte occupies the lowest numbered byte address location in the field.
The sequence of active Attribute Thresholds will appear in the same order as their corresponding Attribute Values.
[Table 7-2] Device Attribute Thresholds Data Structure
7.3.3.2 Data Structure Revision Number
This value is the same as the value used in the Device Attributes Values Data Structure.
7.3.3.3 Individual Thresholds Data Structure
The following defines the 12 bytes that make up the information for each Threshold entry in the Device Attribute Thresholds Data Structure. Attribute
entries in the Individual Threshold Data Structure are in the same order and correspond to the entries in the Individual Attribute Data Structure.
7.3.3.4 Attribute ID Numbers
Attribute ID Numbers supported by the device are the same as Attribute Values Data Structures.
Byte Descriptions
0~1 Data structure revision number
2~361 1st - 30th Individual attribute data
362 ~ 379 Reserved
380 ~ 510 Vendor specific
511 Data structure checksum
Byte Descriptions
0 Attribute ID Number (01h to FFh)
1 Attribute Threshold (for comparison with Attribute Values from 00h to FFh)
00h - "always passing" threshold value to be used for code test purposes
01h - minimum value for normal operation
FDh - maximum value for normal operation
FEh - invalid for threshold value
FFh - "always failing" threshold value to be used for code test purposes
2~11 Reserved (00h)