MICRO COMPONENT SYSTEM WITH REMOTE CONTROL MM-N7 Instruction Manual On/Standby Power Surround Timer AI Off/Sleep On/Off Timer /Clock Mono/ST Shuffle Tape Counter CD Repeat Program /Set Tuner /Band TAPE CD VOL. CD Tuning Mode VOL.
Safety Warnings CLASS 1 LASER PRODUCT GB CLASS 1 LASER PRODUCT KLASSE 1 LASER PRODUKT LUOKAN 1 LASER LAITE KLASS 1 LASER APPARAT PRODUCTO LASER CLASE 1 CAUTION RISK OF ELECTRIC SHOCK. DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE REAR COVER, NO USER SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. This Compact Disc player is classified as a CLASS 1 LASER product.
Contents GB You have just purchased a SAMSUNG micro component system. Please take the time to read these instructions, as they will enable you to set up your player easily and take full advantage of its features. INSTALLING YOUR MICRO COMPONENT SYSTEM Safety Warnings ........................................................................................................................... 2 Where to Install Your Micro Component System .......................................................................
Where to Install Your Micro-Component System GB To take full advantage of your new MICRO component system, follow these installation instructions before connecting the unit. Install the system on a flat, stable surface. Never place this unit on carpeting. Never locate this unit in an outdoor area. Maintain an open space of approximately 4 inches (10 cm) on the sides and rear of the system, for ventilation purposes. Make sure that you have enough room to open the compact disc compartment easily.
Connecting the AM(MW)/LW Aerial The AM(MW)/LW aerial (for long and medium waves) can be: Placed on a stable surface Fixed to the wall (you must first remove the base) The AM aerial connector terminals are located on the rear of the system and are marked AM ANT. Connecting the FM Aerial There are two types of aerials, follow the instructions below (depending on option chosen). 1 To avoid noise interference, check that the loudspeaker wires do not run close to the aerial wires.
Setting the Clock GB Listening to a Compact Disc Your system is equipped with a clock which allows you to turn your system on and aff automatically. You should set the clock: When you purchase the Micro component system You can play 12 cm or 8 cm compact discs without an adapter. 1 2 After a power failure Select the CD function by pressing CD on the front panel. Open the compact disc compartment by pressing down and releasing the cover.
Precautions When Using Compact Discs To guarantee hours of enjoyable listening with your compact discs: Programming the Order of Playback You can decide for yourself: The order in which you listen to the tracks The tracks to which you do not wish to listen This feature can be combined with the Repeat function.
Checking and Changing Programmed Tracks You can check and change your selection of tracks at any time. GB You must have selected at least one track. 1 Press STOP ( ) once if you have started listening to the selection. 2 Press Program/Set. Each time you press Program/Set, the next selection is displayed. 3 Press Program/Set one or more times until the track to be changed is displayed. 4 5 Press SKIP or to select the new track. Press CD ( ) to start listening to the selection.
Searching for and Storing the Radio Stations(continued) 6 Adjust the volume by: Pressing VOLUME + or - on the front panel or Pressing the VOL. + or - buttons on the remote control 7 Select the stereo or mono mode by pressing Mono/ST. Result: The STEREO indicator is displayed when selected. 8 If you do not want to store the radio station found, revert to Step 4 and search for another station. Otherwise: a Press Program/Set. Result: The program number and PROGRAM are displayed for a few seconds.
Listening to a Cassette GB 1 2 3 Selecting the Cassette Playback Mode Switch the system on by pressing On/Standby. Select the TAPE function by pressing TAPE on the front panel. Open the cassette deck by pushing on the corner of the cover marked Push Open until you hear a click and then releasing it. Insert the pre-recorded cassette with the open edge of the tape facing downwards. Close the deck by pushing on it until it clicks into place. 4 5 6 To listen to...
Recording a Radio Programme You can record a radio programme of your choice and listen to it at a later date. 1 Insert a blank cassette in the cassette deck. 2 Press Tuner/Band to select the radio function. 3 Select the radio station that you wish to records. 4 To start recording, press the REC/Pause button. Result: Recording starts immediately. 5 To stop recording temporarily, press the REC/Pause button.
Timer Function GB The timer enables you to switch the system on or off at specific times. Example: You wish to wake up to music every morning. If you no longer want the system to be switched on or off automatically, you must cancel the timer. On/Standby Before setting the timer, check that the current time is correct. For each step, you have a few seconds to set the required options. If you exceed this time, you must start again. 4 5 6 7 Switch the system on by pressing On/Standby.
Setting the System to Switch Off Automatically Equalizer While listening to a compact disc or a cassette, you can set the system to switch off automatically. Example: You wish to go to sleep to music. 1 2 Press AI Off/Sleep. Result: Playback starts and the following indications are displayed: 4 Press the Preset EQ button one or more times until the required option is selected.
Power Surround function GB Connecting to an External Source This machine is equipped with the function of Power Surround which amplifies bass treble output to twice as much for powerful real surround-sound. 1 Press the Power Surround button. Result: P--SURR is displayed for a few seconds. A more powerful resonant sound is diffused. 2 To cancel this function, press Power Surround button again.
Safety Precautions Before Contacting the After-Sales Service The following diagrams illustrate the precautions to be taken when using or moving your Micro component system. 10% It always takes a little time to become familiar with a new appliance. If you have any of the problems listed below, try the solutions given. They may save you the time and inconvenience of an unnecessary service call.
Front Panel View GB 10 Push Open 1 TUNER On/ Standby 2 3 CD Repeat Repeat (A B) CD TAPE AUX 11 Band Tuning Mode CD Synchro REC/Pause 4 13 Power Surround Preset EQ 12 5 14 6 7 8 15 9 Open/Close VOLUME 16 Phones Mic 17 18 1. Function selection buttons 10. Push Open 2. On/Standby 11. AUX 3. CD Repeat 4. Repeat (A 16 12. REC/Pause B) 13. CD Synchro 5. Equalizer preset 14. Power Surround 6. Function control 15. Volume control 7. AI Sleep 16. Open/Close 8.
Remote Control GB 9 On/Standby Power Surround Tuner /Band 1 10 11 Timer AI Off/Sleep On/Off Timer /Clock Mono/ST Shuffle Tape Counter 12 2 3 Program CD Repeat /Set 4 14 5 15 TAPE 6 16 17 CD 18 7 19 VOL. CD 8 13 Tuning Mode 20 CD VOL. 21 1. On/Standby 12. Mono/Stereo 2. AI Off/Sleep 13. Timer/Clock 3. Timer On/Off 14. Tape Counter 4. CD Repeat 15. Shuffle 5. Program/Set 16. Tape auto reverse 6. Tape rewind and fast-forward 17. Tape stop(playback/record) 7.
Technical Specifications Rear Panel View GB SAMSUNG strives to improve its products at all times. Both the design specifications and these user instructions are thus subject to change without notice. 1 (option) 2 3 4 TUNER FM Signal/noise ratio Usable sensitivity Total harmonic distortion AM (MW) Signal/noise ratio Usable sensitivity Total harmonic distortion LW (option) Signal/noise ratio Usable sensitivity Total harmonic distortion SW1.2 (option) Usable sensitivity 60 dB 6 dB 1.
THIS APPLIANCE IS MANUFACTURED BY: ELECTRONICS AH68-00350B
