MICRO COMPONENT SYSTEM WITH REMOTE CONTROL MM-N4 Instruction Manual On/Standby EQ Preset Sleep Timer On/Off Timer/ Clock Program /Set Power Sound CD Repeat Mono/ST AUX TUNER Band TAPE CD VOL. CD Tuning Mode VOL.
Safety Warnings GB Use of controls adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. CLASS 1 LASER PRODUCT KLASSE 1 LASER PRODUKT LUOKAN 1 LASER LAITE KLASS 1 LASER APPARAT PRODUCTO LASER CLASE 1 CAUTION-INVISIBLE LASER RADIATION WHEN OPEN AND INTER LOCKS DEFEATED, AVOID EXPOSURE TO BEAM. This symbol indicates that dangerous voltage constituting of a risk of electric shock is present within this unit. CAUTION RISK OF ELECTRIC SHOCK.
Contents GB You have just purchased a SAMSUNG micro component system. Please take the time to read these instructions, as they will enable you to set up your player easily and take full advantage of its features. INSTALLING YOUR MICRO COMPONENT SYSTEM Safety Warnings ............................................................................................................................ 2 Where to Install Your Micro Component System.......................................................................
Where to Install Your Micro-Component System GB To take full advantage of your new MICRO component system, follow these installation instructions before connecting the unit. Install the system on a flat, stable surface. Never place this unit on carpeting. Never locate this unit in an outdoor area. Maintain an open space of approximately 4 inches (10 cm) on the sides and rear of the system, for ventilation purposes. Make sure that you have enough room to open the compact disc compartment easily.
Connecting the AM Aerial The AM aerial (for long and medium waves) can be: Placed on a stable surface Fixed to the wall (you must first remove the base) Connecting the FM Aerial There are two types of aerial, (depending on option chosen). 1 The AM aerial connector terminals are located on the rear of the system and are marked AM ANT. To avoid noise interference, check that the loudspeaker wires do not run close to the aerial wires. Always keep them at least 2 inches (5 cm) away.
Setting the Clock Your system is equipped with a clock which allows you to turn your system on and off automatically. You should set the clock: When you purchase the Micro component system After a power failure You can play 12 cm or 8 cm compact discs without an adapter. 1 2 Select the CD function by pressing CD on the front panel. 3 Place your disc in the compartment, with the label on the disc facing upwards. 4 Close the compartment by pushing down on the cover until it clicks into place.
Precautions When Using Compact Discs Programming the Order of Playback To guarantee hours of enjoyable listening with your compact discs: You can decide for yourself: The order in which you listen to the tracks The tracks to which you do not wish to listen This feature can be combined with the Repeat function.
Checking and Changing Programmed Tracks You can check and change your selection of tracks at any time. GB Searching for and Storing the Radio Stations You can store up to: (LW/SW option) You must have selected at least one track. 1 Press STOP ( ) once if you have started listening to the selection. 2 Press Program/Set.
Searching for and Storing the Radio Stations(continued) 6 Adjust the volume by: Pressing Volume or on the front panel or Pressing the VOL. + or - buttons on the remote control 7 Select the stereo or mono mode by pressing Mono/ST. Result: The Mono indicator is displayed when selected. 8 If you do not want to store the radio station found, revert to Step 4 and search for another station. Otherwise: a Press Program/Set. Result: The programme number and PROGRAM are displayed for a few seconds.
Listening to a Cassette 1 2 3 Switch the system on by pressing On/Standby. Select the TAPE function by pressing TAPE on the front panel. Open the cassette deck by pushing on the corner of the cover marked PUSH EJECT until you hear a click and then releasing it. Insert the pre-recorded cassette with the open edge of the tape facing downwards. Close the deck by pushing on it until it clicks into place. 4 5 6 To listen to...
Recording a Radio Programme You can record a radio programme of your choice and listen to it at a later date. 1 Insert a blank cassette in the cassette deck. 2 Press TUNER/Band to select the radio function. 3 Select the radio station that you wish to record (see page 8~9). 4 To start recording, press the REC/Pause button. Result: Recording starts immediately. 5 To stop recording temporarily, press the REC/Pause button.
Timer Function GB The timer enables you to switch the system on or off at specific times. Example: You wish to wake up to music every morning. If you no longer want the system to be switched on or off automatically, you must cancel the timer. Before setting the timer, check that the current time is correct. For each step, you have a few seconds to set the required options. If you exceed this time, you must start again.
Sleep Timer Equalizer You can set the system to switch off automatically. Example: You wish to go to sleep to music. 1 2 Press sleep.
Power sound function This machine is equipped with the function of Power Sound, which amplifies bass and improves high key or bass twice as much for you to appreciate powerful real surround-sound. 1 Press the Power Sound button on the front panel. Result: P--SOUND is displayed for a few seconds. A more powerful resonant sound is diffused. 2 To cancel this function, press Power Sound again.
Safety Precautions Before Contacting the After-Sales Service The following diagrams illustrate the precautions to be taken when using or moving your Micro compact system. 10% H 75% 35° 5° It always takes a little time to become familiar with a new appliance. If you have any of the problems listed below, try the solutions given. They may save you the time and inconvenience of an unnecessary service call.
Front Panel View GB 9 1 10 Band TUNER TAPE CD AUX 11 On/Standby Tuning Mode 2 n ow REC/Pause Up D 12 Volume 4 13 SS EQ Prese t S.BA 3 RepeatA<->B) Mute MIC Phone Counter CD COUNTER CD RESET Reset REPEAT Repeat 5 14 CD Synchro 15 Power Sound 6 7 16 8 17 1. Function selection buttons 11. Function control 2. On/Standby 12. REC/Pause 3. Equalizer Preset 13. S. BASS 4. Mute function 14. Repeat A 5. Headphones jack 15. MIC (Option) 6. Counter Reset 16. CD Synchro 7.
Remote Control GB 9 On/Standby Timer On/Off Timer/ Clock 1 10 11 EQ Preset 2 3 Sleep Power Sound Program /Set CD Repeat Mono/ST AUX TUNER 4 14 5 Band TAPE 6 CD 15 16 17 18 7 19 VOL. CD 8 12 13 Tuning Mode CD VOL. 20 21 1. On/Standby 12. AUX 2. EQ Preset 13. Program/Set 3. Power Sound 14. Frequency band selection 4. Sleep 15. Mono/Stereo 5. CD Repeat 16. Tape play 6. Tape rewind and fast-forward 17. Tape stop(playback/record) 7. CD stop and cancel 18.
Technical Specifications Rear Panel View GB SAMSUNG strives to improve its products at all times. Both the design specifications and these user instructions are thus subject to change without notice.
THIS APPLIANCE IS MANUFACTURED BY: ELECTRONICS AH68-00403B
