MICRO COMPONENT AUDIO SYSTEM CD-R/RW PLAYBACK MM-B7 Instruction Manual
Safety Warnings GB CLASS 1 LASER PRODUCT CLASS 1 LASER PRODUCT KLASSE 1 LASER PRODUKT LUOKAN 1 LASER LAITE KLASS 1 LASER APPARAT PRODUCTO LASER CLASE 1 CAUTION RISK OF ELECTRIC SHOCK. DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE REAR COVER, NO USER SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. This Compact Disc player is classified as a CLASS 1 LASER product.
Thank you for buying this SAMSUNG micro component system. Contents Please take time to read these instructions. They will allow you to operate your system with ease and take full advantage of its features. SAFETY WARNINGS .................................................................................................................................................................................. 2 INSTALLING YOUR MICRO COMPONENT SYSTEM Front Panel View ..................................................
Front Panel View GB 1 6 2 TUNER CD 3 Open/Close Band Standby/On Down 4 AUX Up Demo TAPE Phones Tuning Mode Volume Rec/Pause REV.Mode Sound Mode MIC 5 7 8 9 10 11 12 Push Eject 4 13 1. Skip or Search 7. CD Door open/close 2. Function (TUNER/CD/TAPE/AUX) 8. Demo 3. Standby/On 9. MIC(option) 4. Headphone Jack Connector 10. Sound Mode 5. REC/Pause 11. Volume 6. Stop 12. REV.Mode 13.
Remote Control GB Timer On/Off Timer/ Clock 25 24 1 Sleep EQ/P.Sound Aux 23 2 3 4 5 CD SYNC. 10 REV. Mode Shuffle Counter Reset 19 18 CD 6 7 8 9 22 21 20 TAPE 17 +10 Repeat Program/ Set VOL. 16 15 Band Tuning Mode 14 11 VOL. 13 12 Mono/ST Mute 1. Standby/On 13. Mute 2. EQ/P.Sound 14. Volume Control 3. TAPE Rewind 15. Band 4. TAPE Fast-Forward 16. CD Play 5. CD SYNCHRO 17. CD Track Add +10 6. REV. Mode 18. CD Shuffle Play 7. Repeat 19.
Rear Panel View GB 1 2 3 4 6 1. SW Aerial Connector Terminal 2. AM Aerial Connector Terminal 3. FM Aerial Connector Terminal 4. AUX-Input 5. Loudspeakers Connnector Terminals 6.
Where to Install Your Micro Component System Inserting Remote Control Batteries GB To take full advantage of your new micro component system, follow these installation instructions before connecting the unit. Install the system on a flat, stable surface. Never place this unit on carpeting. Never place this unit in an outdoor area. Maintain an open space of approximately 6 inches (15 cm) on the sides and rear of the system, for ventilation purposes.
Connecting to an External Source Speaker Connection GB The auxiliary input can be used to take advantage of the sound quality of your micro component system when listening to other sources. Examples: A television A video disc player A Hi-Fi stereo video cassette recorder To connect the external source, the source must have an audio output. In addition, you need an RCA connection cable. 1 Set the system to standby mode and disconnect it and the external source from the main.
Connecting the AM (MW)/LW Aerial GB The AM aerial (for long and medium waves) can be: Placed on a stable surface Fixed to the wall (you must first remove the base) The AM aerial connector terminals are located on the rear of the system and are marked AM . To avoid noise interference, check that the loudspeaker wires do not run close to the aerial wires. Always keep them at least 2 inches (5 cm) away. Connecting the FM Aerial How to connect a COAXIAL TYPE aerial.
Viewing the Various Functions on Your System Setting the Clock GB You can view the various functions available on your system. 1 Press the Demo button. Result: The various functions available are listed in turn on the display. Your system is equipped with a clock which allows you to turn your system on and off automatically.
Listening to a Compact Disc Selecting a Track GB Do not use CDs of irregular shapes like heart or octagon shapes. The performance of the player may be degraded. You can select the track you wish to listen to, either when the compact disc player is stopped or when a disc is playing. To start playback at the beginning of the... 1 2 Press the CD( )button on the main body and select CD. Press the Open/Close( ) button. Result: The CD tray is opened.
Function to skip through 10 tracks at a time Repeating One or All Tracks on the Compact Discs GB Press the +10 button briefly while playing back a CD. The track 10 tracks after the current one will then be played back. Example: If you want to select track 43 during playback of track 15, press the +10 button three times, and then press the button three times. You can repeat indefinitely: A specific track on a compact disc. All tracks on the compact disc selected.
Programming the Order of Playback Checking or Changing Programmed Tracks GB You can decide: You can check or change your selection of tracks at any time. The order of the track desired to listen The track not desired to listen A maximum of up to 24 order of tracks desired to listen may be programmed. Before selecting the track, the CD player should be stopped. This function may be used simultaneously with the CD Repeat function.
Searching for and Storing the Radio Stations GB Selecting a Stored Station You can store up to: You can listen to a stored radio station as follows: 15 FM stations 15 AM stations 15 FM stations 8 MW stations 7 LW stations 15 FM stations 5 MW stations 5 SW1 stations 5 SW2 stations 1 2 (option) 1 2 Switch the system on by pressing Standby/On ( 3 Select the radio station as follows. Select the required frequency band by pressing TUNER(Band) on the front panel.
Selecting the Cassette Playback Mode Listening to a Cassette GB Always treat your cassettes with care; refer, if necessary, to the section entitled “Precautions When Using Audio Cassettes” on page 23. 1 2 3 4 5 Switch the system on by pressing Standby/On ( ). Open the cassette deck by pushing on the corner of the cover marked Push Eject ( ) until you hear a click and then releasing it. When the display indicates... The micro component system plays back...
Recording a Compact Disc GB Direct recording You can record a compact disc on a cassette in two different ways: Synchronised recording Direct recording The direct recording mode enables you to start recording with any track on the compact disc. You do not need to adjust the volume, as it has no effect on the recording. Synchronised recording 1 2 3 4 This feature enables you to synchronize the start of the recording with the start of the disc or track of your choice.
Timer Function GB The timer enables you to switch the system on or off at specific times. Example: You wish to wake up to music every morning. 9 Press Stanby/On ( ) to set the system to standby mode. is displayed to the bottom left of the time, indicating that Result: the timer has been set. The system will switch on and off automatically at the required times. If you no longer want the system to be switched on or off automatically, you must cancel the timer.
Canceling the Timer Mute Function GB After having set the timer, it will start automatically as shown by the TIMER indication on the display. If you no longer wish to use the timer, you must cancel it. You can stop the timer at any time (system on or in standby mode). To... Press Timer On/Off... Cancel the timer Once. Result: is no longer displayed. Restart the timer Twice. Result: is displayed again. You can turn the sound off temporarily on your system.
Setting the System to Switch off Automatically Connecting Headphones GB While listening to a compact disc or a cassette, you can set the system to switch off automatically Example: You wish to go to sleep to music. 1 Press Sleep.
Cleaning Your Micro Component System Safety Precautions GB The following diagrams illustrate the precautions to be taken when using or moving your micro component system.
Precautions When Using Compact Discs Before Contacting the After-Sales Service GB Handle your compact discs with care. Always hold them by the edges to avoid leaving fingerprints on the shiny surface. When you have finished playing a compact disc, always put it back in its case. Do not fix paper or adhesive tape to the discs and do not write on the label. Clean them with a special-purpose cloth.
Technical Specifications GB SAMSUNG strives to improve its products at all times. Both the design specifications and these user instructions are thus subject to change without notice. RADIO LW(option) Usable sensitivity SW(option) Usable sensitivity 60 dB 40 dB AM (MW) Signal/noise ratio 40 dB Usable sensitivity 54 dB Total harmonic distortion 2% FM Signal/noise ratio 62 dB Usable sensitivity 3 dB Total harmonic distortion 0.
THIS APPLIANCE IS MANUFACTURED BY: ELECTRONICS AH68-01099J
