Installation manual

E-2
Safety Precautions
Read carefully this installation manual before
installation and check if the DMS is installed correctly
after installation.
 Do not attempt to install or repair this DMS by yourself.
This DMS contains no user-serviceable parts.
Always consult authorized service personnel for repairs.
When moving, consult authorized service personnel for
disconnection and installation of the DMS.
Ensure that the wall is strong enough to support the
weight of the DMS.
Must install the DMS with rated power supply.
The DMS must be installed according to
the national electrical rules by an installation specialist.
If you wish to uninstall the DMS, consult an authorized
installation center.
WARNING
CAUTION
 Do not use inflammable gases near the DMS.
Do not install the DMS in a location where
it will come into contact with combustible gases,
machine oil, sulphide gas, etc.
Avoid locations where acid/alkali solution or special
spray is used.
Choose a location that is dry and sunny, but not exposed
to direct sunlight. Suitable temperature is between
0°C(32°F) and 39°C(102.2°F).
 Do not spill water into the DMS.
Do not apply tensile strength to the cable to avoid cable
damage.
Do not press the buttons with a sharp object.
Do not connect the power cable to the control terminal.
If the DMS is installed in a hospital or other special
places, it should not affect other electronic devices.
This installation manual describes how to install the DMS. For installation of other
optional accessories, refer to the appropriate installation manual.
MIM-D00_IM_E_29919-1.indd 2 2008-09-10 ｿﾀﾈﾄ 1:27:10