Installation manual

E-14
DMS External Display
LED Status Display
1
2
3
4
5
6
7
8
9
10

Power (Red)
Power display.
The power display is on when there’s a power input.

CPU Alive(Yellow)
Flickers every second if the CPU is operating normally.
(The CPU is in waiting status and the CPU Alive display is off
initially when powered up.)

Linked (Green)
Internet cable connection status display.
The display is on when connected to the internet.

Active (Green)
Flickers during data transceive.

RS485 Tx (Green)
Flickers during data transmission from the DMS to
the centralized controller.
(Starts flickering once the tracking is complete.)

RS485 Rx (Green)
Flickers during data transmission from the centralized
controller to the DMS.

DI 1 Status (Green)
Lights on when using the external contact signal control.
(Refer to page 23)

DI 2 Status (Green)
Lights on when using the external contact signal control.
(Refer to page 23)

A/C Running
(Green)
DMS status indicator/Running status of indoor unit indicator
You may setup A/C Running LED to indicate either DMS status
or Indoor unit operation.
- DMS status: Green light will flicker every 5 seconds when
DMS operates normally.
- Running status of indoor unit: Solid green light will turn on
when the indoor units operate normally.
(at least 1 indoor unit)

Error (Green)
Lights on if there is an error on at least one indoor or outdoor
unit. Also Lights on when there is a communication error.
MIM-D00_IM_E_29919-1.indd 14 2008-09-10 ｿﾀﾈﾄ 1:27:23