User Manual

E-124
6
System Settings (Continued)
6
Tracking completed message will appear.
Select Zone initialization mode you want and click [OK].
 Not initialize: No zone information initialization will be
made.
 Initialize individually: Initialize zone information as
individual mode.
 Initialize by group: Initialize zone information as group
mode.
Note If tracking is executed successfully when interface
module is set for communication mode setting by
channel, virtual centralized controller will be assigned
to each channel.
For about centralized controller’s address, address
11~15 will be assigned to channel 0~4 for each.
If there is interface module communication channel,
tracking for centralized controller will be restricted
for the centralized controller which are in the range of
0~10.
If there is no searched interface module, centralized
controller, and SIM/PIM, it is regarded as DVM tracking
failure.
If there are devices which have same address, first
searched device will be registered only.
The number of centralized controller contains the
number of virtual centralized controller which is used
in interface module communication.
The number of indoor unit contains the number of
indoor unit, ERV, AHU, and GHP.
If you execute tracking, system setting will be initialized.
If tracking result does not match with actual installation
information, there can be critical error in additional
functions such as power distribution and peak power
control.
Make sure that tracking information matches to actual
installation information after tracking.
MIM-D00A_DMS2_IB_E 32140-2.indd 124 2010-05-17 ｿﾀﾀ・10:42:42