Flat Panel Television User Manual
Table Of Contents
- TOC
- 01-Overview
- 02-Address Space
- 03-Addressing Modes
- 04-Control Registers
- 05-Interrupt Structure
- 06-Instruction Set
- 07-Clock and Power Circuits
- 08-RESET
- 09-IO PORTS
- 10-BASIC TIMER and TIMER 0
- 11-Timer1
- 12-CounterA
- 13-Timer2
- 14-EMBEDDED Flash Memory Interface
- 15-Low Voltagge Detector
- 16-Electrical Data
- 17-Mechanical Data
- 18-Flash MCU
- 19-Development Tool
- TOC.pdf
CONTROL REGISTERS S3F80P5_UM_ REV1.00
P1CONH — Port 1 Control Register (High Byte) EAH Set1 Bank0
Bit Identifier .7 .6 .5 .4 .3 .2 .1 .0
Reset Value
1 1 1 1 1 1 1 1
Read/Write
R/W R/W R/W R/W R/W R/W R/W R/W
Addressing Mode
Register addressing mode only
.7 and .6 P1.7 Mode Selection Bits
0 0 C-MOS input mode
0 1 Open-drain output mode
1 0 Push-pull output mode
1 1 C-MOS input with pull up mode
.5 and .4 P1.6 Mode Selection Bits
0 0 C-MOS input mode
0 1 Open-drain output mode
1 0 Push-pull output mode
1 1 C-MOS input with pull up mode
.3 and .2 P1.5 Mode Selection Bits
0 0 C-MOS input mode
0 1 Open-drain output mode
1 0 Push-pull output mode
1 1 C-MOS input with pull up mode
.1 and .0 P1.4 Mode Selection Bits
0 0 C-MOS input mode
0 1 Open-drain output mode
1 0 Push-pull output mode
1 1 C-MOS input with pull up mode
NOTE: P1CONH is available in case of S3F80P5’s 32-pin, not in 28-pin.
P1CONH’s reset value is 0FFH. After reset, initial values of port1.4-.7 become CMOS input with pull-up
mode.
4-24