Flat Panel Television User Manual
Table Of Contents
- TOC
- 01-Overview
- 02-Address Space
- 03-Addressing Modes
- 04-Control Registers
- 05-Interrupt Structure
- 06-Instruction Set
- 07-Clock and Power Circuits
- 08-RESET
- 09-IO PORTS
- 10-BASIC TIMER and TIMER 0
- 11-Timer1
- 12-CounterA
- 13-Timer2
- 14-EMBEDDED Flash Memory Interface
- 15-Low Voltagge Detector
- 16-Electrical Data
- 17-Mechanical Data
- 18-Flash MCU
- 19-Development Tool
- TOC.pdf
S3F80P5_UM_ REV1.00 CONTROL REGISTERS
P0CONH — Port 0 Control Register (High Byte) E8H Set1 Bank0
Bit Identifier .7 .6 .5 .4 .3 .2 .1 .0
Reset Value
0 0 0 0 0 0 0 0
Read/Write
R/W R/W R/W R/W R/W R/W R/W R/W
Addressing Mode
Register addressing mode only
.7 and .6 P0.7/INT4 Mode Selection Bits
0 0 C-MOS input mode; interrupt on falling edges
0 1 C-MOS input mode; interrupt on rising and falling edges
1 0 Push-pull output mode
1 1 C-MOS input mode; interrupt on rising edges
.5 and .4 P0.6/INT4 Mode Selection Bits
0 0 C-MOS input mode; interrupt on falling edges
0 1 C-MOS input mode; interrupt on rising and falling edges
1 0 Push-pull output mode
1 1 C-MOS input mode; interrupt on rising edges
.3 and .2 P0.5/INT4 Mode Selection Bits
0 0 C-MOS input mode; interrupt on falling edges
0 1 C-MOS input mode; interrupt on rising and falling edges
1 0 Push-pull output mode
1 1 C-MOS input mode; interrupt on rising edges
.1 and .0 P0.4/INT4 Mode Selection Bits
0 0 C-MOS input mode; interrupt on falling edges
0 1 C-MOS input mode; interrupt on rising and falling edges
1 0 Push-pull output mode
1 1 C-MOS input mode; interrupt on rising edges
NOTES:
1. The INT4 external interrupts at the P0.7−P0.4 pins share the same interrupt level (IRQ7) and interrupt vector address
(E8H).
2. You can assign pull-up resistors to individual port 0 pins by making the appropriate settings to the P0PUR register.
(P0PUR.7 − P0PUR.4)
4-19