Flat Panel Television User Manual
Table Of Contents
- TOC
- 01-Overview
- 02-Address Space
- 03-Addressing Modes
- 04-Control Registers
- 05-Interrupt Structure
- 06-Instruction Set
- 07-Clock and Power Circuits
- 08-RESET
- 09-IO PORTS
- 10-BASIC TIMER and TIMER 0
- 11-Timer1
- 12-CounterA
- 13-Timer2
- 14-EMBEDDED Flash Memory Interface
- 15-Low Voltagge Detector
- 16-Electrical Data
- 17-Mechanical Data
- 18-Flash MCU
- 19-Development Tool
- TOC.pdf
CONTROL REGISTERS S3F80P5_UM_ REV1.00
FMSECH — Flash Memory Sector Address Register(High Byte) ECH Set1 Bank1
Bit Identifier .7 .6 .5 .4 .3 .2 .1 .0
Reset Value
0 0 0 0 0 0 0 0
Read/Write
R/W R/W R/W R/W R/W R/W R/W R/W
Addressing Mode
Register addressing mode only
.7− .0
Flash Memory Sector Address (High Byte)
Note: The high-byte flash memory sector address pointer value is the higher eight
bits of the 16-bit pointer address.
FMSECL
— Flash Memory Sector Address Register(Low Byte) EDH Set1 Bank1
Bit Identifier .7 .6 .5 .4 .3 .2 .1 .0
Reset Value
0 0 0 0 0 0 0 0
Read/Write
R/W R/W R/W R/W R/W R/W R/W R/W
Addressing Mode
Register addressing mode only
.7− .0
Flash Memory Sector Address (Low Byte)
Note: The low-byte flash memory sector address pointer value is the lower eight bits
of the 16-bit pointer address.
FMUSR
— Flash Memory User Programming Enable Register EEH Set1 Bank1
Bit Identifier .7 .6 .5 .4 .3 .2 .1 .0
Reset Value
0 0 0 0 0 0 0 0
Read/Write
R/W R/W R/W R/W R/W R/W R/W R/W
Addressing Mode
Register addressing mode only
.7−.0
Flash Memory User Programming Enable Bits
1 0 1 0 0 1 0 1 Enable user programming mode
Other values Disable user programming mode
NOTES:
1. To enable flash memory user programming, write 10100101B to FMUSR.
2. To disable flash memory operation, write other value except 10100101B into FMUSR.
4-12