Flat Panel Television User Manual
Table Of Contents
- TOC
- 01-Overview
- 02-Address Space
- 03-Addressing Modes
- 04-Control Registers
- 05-Interrupt Structure
- 06-Instruction Set
- 07-Clock and Power Circuits
- 08-RESET
- 09-IO PORTS
- 10-BASIC TIMER and TIMER 0
- 11-Timer1
- 12-CounterA
- 13-Timer2
- 14-EMBEDDED Flash Memory Interface
- 15-Low Voltagge Detector
- 16-Electrical Data
- 17-Mechanical Data
- 18-Flash MCU
- 19-Development Tool
- TOC.pdf
S3F80P5_UM_ REV1.00 ADDRESS SPACE
PROGRAMMING TIP — Standard Stack Operations Using PUSH and POP
The following example shows you how to perform stack operations in the internal register file using PUSH and
POP instructions:
LD SPL,#0FFH ; SPL ← FFH
; (Normally, the SPL is set to 0FFH by the initialization
; routine)
•
•
•
PUSH PP ; Stack address 0FEH ← PP
PUSH RP0 ; Stack address 0FDH ← RP0
PUSH RP1 ; Stack address 0FCH ← RP1
PUSH R3 ; Stack address 0FBH ← R3
•
•
•
POP R3 ; R3 ← Stack address 0FBH
POP RP1 ; RP1 ← Stack address 0FCH
POP RP0 ; RP0 ← Stack address 0FDH
POP PP ; PP ← Stack address 0FEH
2-21