Flat Panel Television User Manual
Table Of Contents
- TOC
- 01-Overview
- 02-Address Space
- 03-Addressing Modes
- 04-Control Registers
- 05-Interrupt Structure
- 06-Instruction Set
- 07-Clock and Power Circuits
- 08-RESET
- 09-IO PORTS
- 10-BASIC TIMER and TIMER 0
- 11-Timer1
- 12-CounterA
- 13-Timer2
- 14-EMBEDDED Flash Memory Interface
- 15-Low Voltagge Detector
- 16-Electrical Data
- 17-Mechanical Data
- 18-Flash MCU
- 19-Development Tool
- TOC.pdf
TIMER 1 S3F80P5_UM_ REV1.00
TIMER 1 OVERFLOW INTERRUPT
Timer 1 can be programmed to generate an overflow interrupt (IRQ1, F4H) whenever an overflow occurs in the
16-bit up counter. When you set the Timer 1 overflow interrupt enable bit, T1CON.2, to “1”, the overflow interrupt
is generated each time the 16-bit up counter reaches ‘FFFFH’. After the interrupt request is generated, the
counter value is automatically cleared to ‘00H’ and up counting resumes. By writing a “1” to T1CON.3, you can
clear/reset the 16-bit counter value at any time during program operation.
TIMER 1 CAPTURE INTERRUPT
Timer 1 can be used to generate a capture interrupt (IRQ1, vector F6H) whenever a triggering condition is
detected at the P3.0 pin. The T1CON.5 and T1CON.4 bit-pair setting is used to select the trigger condition for
capture mode operation: rising edges, falling edges, or both signal edges.
In capture mode, program software can poll the Timer 1 match/capture interrupt pending bit, T1CON.0, to detect
when a Timer 1 capture interrupt pending condition exists (T1CON.0 = “1”). When the interrupt request is
acknowledged by the CPU and the service routine starts, the interrupt service routine for vector F6H must clear
the interrupt pending condition by writing a “0” to T1CON.0.
Interrupt
Enable/Disable
(T1CON.1)
IRQ1
(T1INT)
P3.0
Timer 1 Data
IRQ1 (T1OVF)
16-Bit Up Counter
CLK
T1CON.5
T1CON.4
Pending
(T1CON.0)
T1CON.2
Figure 11-1. Simplified Timer 1 Function Diagram: Capture Mode
11-2