Flat Panel Television User Manual
Table Of Contents
- TOC
- 01-Overview
- 02-Address Space
- 03-Addressing Modes
- 04-Control Registers
- 05-Interrupt Structure
- 06-Instruction Set
- 07-Clock and Power Circuits
- 08-RESET
- 09-IO PORTS
- 10-BASIC TIMER and TIMER 0
- 11-Timer1
- 12-CounterA
- 13-Timer2
- 14-EMBEDDED Flash Memory Interface
- 15-Low Voltagge Detector
- 16-Electrical Data
- 17-Mechanical Data
- 18-Flash MCU
- 19-Development Tool
- TOC.pdf
S3F80P5_UM_ REV1.00 INSTRUCTION SET
PUSHUD — Push User Stack (Decrementing)
PUSHUD dst,src
Operation: IR ← IR – 1
dst ← src
This instruction is used to address user-defined stacks in the register file. PUSHUD decrements
the user stack pointer and loads the contents of the source into the register addressed by the
decremented stack pointer.
Flags: No flags are affected.
Format:
Bytes Cycles Opcode
(Hex)
Addr Mode
dst src
opc dst src
3 8 82 IR R
Example: Given: Register 00H = 03H, register 01H = 05H, and register 02H = 1AH:
PUSHUD @00H,01H → Register 00H = 02H, register 01H = 05H, register 02H = 05H
If the user stack pointer (register 00H, for example) contains the value 03H, the statement
"PUSHUD @00H,01H" decrements the user stack pointer by one, leaving the value 02H. The
01H register value, 05H, is then loaded into the register addressed by the decremented user
stack pointer.
6-67