Flat Panel Television User Manual
Table Of Contents
- TOC
- 01-Overview
- 02-Address Space
- 03-Addressing Modes
- 04-Control Registers
- 05-Interrupt Structure
- 06-Instruction Set
- 07-Clock and Power Circuits
- 08-RESET
- 09-IO PORTS
- 10-BASIC TIMER and TIMER 0
- 11-Timer1
- 12-CounterA
- 13-Timer2
- 14-EMBEDDED Flash Memory Interface
- 15-Low Voltagge Detector
- 16-Electrical Data
- 17-Mechanical Data
- 18-Flash MCU
- 19-Development Tool
- TOC.pdf
CONTROL REGISTERS S3F80P5_UM_ REV1.00
IPH — Instruction Pointer (High Byte) DAH Set1 Bank0
Bit Identifier .7 .6 .5 .4 .3 .2 .1 .0
Reset Value
x x x x x x x x
Read/Write
R/W R/W R/W R/W R/W R/W R/W R/W
Addressing Mode
Register addressing mode only
.7− .1
Instruction Pointer Address (High Byte)
The high-byte instruction pointer value is the upper eight bits of the 16-bit instruction
pointer address (IP15–IP8). The lower byte of the IP address is located in the IPL
register (DBH).
IPL
— Instruction Pointer (Low Byte) DBH Set1 Bank0
Bit Identifier .7 .6 .5 .4 .3 .2 .1 .0
Reset Value
x x x x x x x x
Read/Write
R/W R/W R/W R/W R/W R/W R/W R/W
Addressing Mode
Register addressing mode only
.7− .0
Instruction Pointer Address (Low Byte)
The low-byte instruction pointer value is the lower eight bits of the 16-bit instruction
pointer address (IP7–IP0). The upper byte of the IP address is located in the IPH
register (DAH).
4-14