User Manual

E-10

Heating Your Room

(Except cooling only models)

If necessary, press (ON/OFF) button.

Result: : ◆ The On/Off indicator on the wired remote

controller comes on.

◆ The air conditioner runs in the mode

selected when the unit was last used.

You must select the HEAT mode if you wish to adjust the :

◆ Heating temperature

◆ Fan speed when heating

To select the HEAT mode, press the button until

is displayed at the top of the wired remote controller.

Result: : ◆

The air conditioner runs in HEAT mode.

The air conditioner is fitted with a protection

mechanism to prevent the unit from being

damaged when it is started immediately

after being:

◆ Plugged in

◆ Stopped

lt will start up normally after three minutes.

IMPORTANT

◆ You can change modes at any time.

You can select the HEAT mode only in heat pump models.