Quick Guide
Table Of Contents
- Important safety instructions
- Electrical requirements
- Hood exhaust
- Damage - Shipment/Installation
- Parts included
- Tools you will need
- Mounting space
- 1. Placement of the mounting plate
- 2. Ventilation types (choose a, b or c)
- 3. Installation
- 4. Before you use your microwave
13
Step-by-step installation guide
3. Remove the screw that holds the blower motor
and carefully pull out the blower unit. The wires will
extend far enough to allow you to adjust the blower
unit.
CAUTION: To avoid breaking or cracking the blower
blade, do not touch the blade. Hold the outer case of the
blower when you pull it out or put it back in place.
4. Roll the blower unit 90 ° so that the fan blade
openings are facing toward the front of the
microwave.
Before Roll
After Roll
5. Place the blower unit back into the opening.
CAUTION: Do not pull or stretch the blower unit wiring.
Make sure the wires are not pinched.
6. Remove the metal vent fan cover on the back of the
microwave by sliding it up.
7. Close the blower door. Slide blower shield onto the
top of the blower door opening.
8. Secure the blower to the microwave using the blower
retaining screws from Step 1.
Back of
Microwave Oven
Blower Retaining
Screws
Blower Retaining
Screw
B2. INSTALLING THE CHARCOAL FILTER
1. Remove the screws on the top of the grille using a
#1 Phillips screwdriver.
2. Open the door.
3. Remove the grille.
• Push the grille left, and then pull the grille straight o.
Charcoal
filter
4. Install the charocal filter. When properly installed,
the wire mesh of the filter should be visible from the
front.
5. Reinstall the grille and the screws.
6. Close the door.
Insert mesh-side up
SMH1927_XAA_DE68-04108A-07_EN.indd 13SMH1927_XAA_DE68-04108A-07_EN.indd 13 2022-01-20 �� 10:15:532022-01-20 �� 10:15:53