Quick Guide

8
Step-by-step installation guide
1. PLACEMENT OF THE MOUNTING PLATE
A. REMOVING THE MICROWAVE OVEN
FROM THE CARTON/REMOVING THE
MOUNTING PLATE
1. Remove the installation instructions, Exhaust
adaptor, lters, glass tray, and the small hardware
bag. Do not remove the Styrofoam protecting the
front of the oven.
2. Fold back all 4 carton aps fully against carton
sides. Then carefully roll the oven and carton over
onto the top side. The oven should be resting in the
Styrofoam.
Styrofoam
Carton
Carton
Styrofoam
3. Pull the carton up and off the oven.
4. Remove and properly discard plastic bags.
Screws
Screws
Mounting Plate
Screws
Mounting Plate
Screws
5. Remove the 2 screws from the mounting plate.
This plate will be used as the rear wall template and
for mounting.
NOTE: Retain the two screws. You will need to re-insert
the screws in their original locations after you have
removed the mounting plate.
B. FINDING THE WALL STUDS
Wall Studs
Center
Center
Wall Studs
1. Find the studs using one of the following methods:
A. With a stud nder – a magnetic device which
locates nails.
OR
B. Use a hammer to tap lightly across the mounting
surface until you hear a solid sound. This will
indicate a stud location.
2. After locating the stud(s), locate the stud’s center by
probing the wall with a small nail to nd the edges
of the stud. Then, place a mark halfway between
the edges. The center of any adjacent studs should
be 16" or 24" from this mark.
3. Draw a line down the center of the studs.
THE MICROWAVE MUST BE CONNECTED TO AT LEAST
ONE WALL STUD.
DE68-04108A-08_IM_ME18H704SFB_AA_EN.indd 8DE68-04108A-08_IM_ME18H704SFB_AA_EN.indd 8 2024-03-05 오전 11:50:112024-03-05 오전 11:50:11