Quick Guide

3
General information
IMPORTANT SAFETY INSTRUCTIONS
This product requires a three-prong grounded outlet.
The installer must perform a ground continuity
check on the power outlet box before beginning the
installation to ensure that the outlet box is properly
grounded. If not properly grounded, or if the outlet box
does not meet electrical requirements noted (under
ELECTRICAL REQUIREMENTS), a qualied electrician
should be employed to correct any deciencies.
Insure proper
ground exists
before use
CAUTION: For personal safety,
remove the house fuse or open
the circuit breaker before
beginning the installation to
avoid severe or fatal shock
injury.
CAUTION: For personal safety, the mounting surface
must be capable of supporting the cabinet load in
addition to the added weight of this 69 pound product,
plus additional oven loads of up to 50 pounds or a total
weight of 109 pounds.
CAUTION: For personal safety, do not install this
product in cabinetry congured as an island or a
peninsula. The microwave oven must be mounted to
BOTH a top cabinet AND a wall.
NOTE: For easier installation and personal safety, we
recommend that two people install this product.
IMPORTANT – PLEASE READ CAREFULLY. FOR
PERSONAL SAFETY, THIS APPLIANCE MUST BE
PROPERLY GROUNDED TO AVOID SEVERE OR FATAL
SHOCK.
Insure proper
ground exists
before use
Insure proper
ground exists
before use.
The power cord of this
appliance is equipped with a
three-prong (grounding) plug
which mates with a standard
three-prong (grounding) wall
receptacle to minimize the
possibility of electric shock
hazard from this appliance.
You should have the wall receptacle and circuit
checked by a qualied electrician to make sure the
receptacle is properly grounded.
If you have a standard two-prong wall receptacle, it
is very important to have it replaced with a properly
grounded three-prong wall receptacle, installed by a
qualied electrician.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT, DEFORM
OR REMOVE ANY OF THE PRONGS FROM THE POWER
CORD. DO NOT USE WITH AN EXTENSION CORD.
ELECTRICAL REQUIREMENTS
Product rating is 120 volts AC, 60 Hertz. This product
must be connected to a supply circuit of the proper
voltage and frequency. Wire size must conform to
the requirements of the National Electrical Code or
the prevailing local code for this kilowatt rating. The
power supply cord and plug should be brought to a
separate branch circuit single grounded outlet of at
least 15 A and max of 20 A. 20 A is recommended for
multifamily buildings. The outlet box should be located
in the cabinet above the microwave oven. The outlet
box and supply circuit should be installed by a qualied
electrician and conform to the National Electrical Code
or the prevailing local code.
DE68-04108A-08_IM_ME18H704SFB_AA_EN.indd 3DE68-04108A-08_IM_ME18H704SFB_AA_EN.indd 3 2024-03-05 오전 11:50:102024-03-05 오전 11:50:10