Quick Guide

17
Step-by-step installation guide
1. Lift the microwave, tilt it
forward, and hook the slots
at the back bottom edge
onto the four lower tabs of
the mounting plate.
2. R
otate the front
of
the oven up
against the cabinet
bottom.
3. Insert a self-aligning screw through the top
center cabinet hole. Temporarily secure the oven
by turning the screw at least two full turns after
the threads have engaged. (It will be completely
tightened later.) Be sure to keep the power cord
tight. Be careful not to pinch the cord, especially
when mounting ush to the bottom of the cabinet.
Cabinet Front
Filler Block
Microwave Oven Top
Self-Aligning Screw
Equivalent to
Depth of
Cabinet Recess
Cabinet Bottom Shelf
Equivalent to
Depth of Cabinet
Recess
Cabinet Bottom Shelf
Microwave Oven Top
Cabinet Front
Filler Block
Self-Aligning Screw
4. Attach the microwave oven to the top cabinet.
5. Insert the 2 self-aligning screws through the
cabinet bottom and, if used, through the ller
blocks into the outer top of the unit. (See the
illustration above). Continue to support the unit
until both screws are inserted and engaged at least
two full turns, then fully tighten both screws until
the unit is secure.
6. Install the grease lters. See the Owner’s Manual
packed with the microwave for instructions.
NOTE: For models with installed grease lters, you do
not need to install a lter
E. CONNECT THE DUCTWORK FOR OUTSIDE
TOP EXHAUST
House Duct
1. Extend the house duct down to connect to the
exhaust adaptor.
2. Seal the exhaust duct joints using duct tape.
DE68-04108A-08_IM_ME18H704SFB_AA_EN.indd 17DE68-04108A-08_IM_ME18H704SFB_AA_EN.indd 17 2024-03-05 오전 11:50:132024-03-05 오전 11:50:13