Quick Guide
Table Of Contents
- Important safety instructions
- Electrical requirements
- Hood exhaust
- Damage - Shipment/Installation
- Parts included
- Tools you will need
- Mounting space
- 1. Placement of the mounting plate
- 2. Ventilation types (choose a, b or c)
- 3. Installation
- 4. Before you use your microwave
16
Step-by-step installation guide
To use the toggle bolts:
Wall
Toggle Wings
Toggle
Bolt
Bolt End
Spacing for Toggles More
Than Wall Thickness
Mounting
Plate
Bolt End
Mounting
Plate
Toggle
Bolt
Wall
Toggle Wings
3. Place the mounting plate against the wall, pinch the
wings of each toggle together, and then insert the
toggle wings of each toggle into and through the
holes in the wall.
NOTE: Before tightening the toggle bolts and wood
screw, make sure the bottom of the Mounting plate
runs along the bottom Horizontal line of the "Rear wall
Template" and the Mounting plate is properly centered
under the cabinet.
CAUTION: Be careful to avoid pinching your ngers
between the back of the mounting plate and the wall.
4. Tighten all bolts. Pull the plate away from the wall
to help tighten the bolts. Tighten the screw.
C. USE THE TOP CABINET TEMPLATE TO
PREPARE THE CABINET ABOVE
You need to drill holes for the top support screws and a
hole large enough for the power cord to t through.
• Read the instructions on the TOP CABINET
TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the TOP
CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes in
the cabinet bottom.
D. MOUNT THE MICROWAVE OVEN
FOR EASIER INSTALLATION AND PERSONAL SAFETY,
WE RECOMMEND THAT TWO PEOPLE INSTALL THIS
MICROWAVE OVEN.
IMPORTANT: Do not grip the handle or use the handle
during installation to support the microwave.
NOTE: If your cabinet is metal, use the nylon grommet
in the power cord hole to prevent the cord from being
cut.
NOTE: Filler blocks are required when mounting this
unit under any cabinet with a recessed bottom or front
overhang. (See page 9.)
IMPORTANT: The case damage that will occur from over
tightening screws if you do not use ller blocks is not
covered under warranty.
IMPORTANT: For models with the grease lter
installed, don’t push up on the lter when you mount
the oven.
Grease Filter Grease Filter
Grease Filter Grease Filter
NOTE: When mounting the microwave oven, thread
the power cord through hole in the bottom of the top
cabinet. Keep it tight throughout Steps 1–3. Do not
pinch the cord or lift the oven by pulling cord.
DE68-04108A-08_IM_ME18H704SFB_AA_EN.indd 16DE68-04108A-08_IM_ME18H704SFB_AA_EN.indd 16 2024-03-05 오전 11:50:132024-03-05 오전 11:50:13