Quick Guide

13
Step-by-step installation guide
3. Remove the screw that holds the blower motor and
carefully pull out the blower unit. The wires will
extend far enough to allow you to adjust the blower
unit.
CAUTION: To avoid breaking or cracking the blower
blade, do not touch the blade. Hold the outer case of
the blower when you pull it out or put it back in place.
4. Roll the blower unit 90 ° so that the fan blade
openings are facing toward the front of the
microwave.
Before Roll
After Roll
5. Place the blower unit back into the opening.
CAUTION: Do not pull or stretch the blower unit wiring.
Make sure the wires are not pinched.
6. Remove the metal vent fan cover on the back of the
microwave by sliding it up.
7. Close the blower door. Slide blower shield onto the
top of the blower door opening.
8. Secure the blower to the microwave using the
blower retaining screws from Step 1.
Back of
Microwave Oven
Blower Retaining
Screws
Blower Retaining
Screw
B2. INSTALLING THE CHARCOAL FILTER
1. Open the door before turning on the power at the
main power supply.
2. Remove the vent grille mounting screws.
3.
Slide the vent grille to the left, then pull it straight out.
4. Install the charcoal lter. Slide a new charcoal lter
into place. The lter should rest at the angle shown.
Charcoal lter
The lter angle
5. Reinstall the vent grille and 2 screws.
6. Close the door.
DE68-04108A-08_IM_ME18H704SFB_AA_EN.indd 13DE68-04108A-08_IM_ME18H704SFB_AA_EN.indd 13 2024-03-05 오전 11:50:122024-03-05 오전 11:50:12