Quick Guide

10
Step-by-step installation guide
D. ALIGNING THE WALL PLATE
C
L
CAUTION: Wear gloves to avoid cutting
fingers on sharp edges.
Area E
Hole B
Hole A
Centerline
notches
Draw a Vertical Line
on Wall from Center
of Top Cabinet
Draw a Horizontal line on wall from
bottom of “Rear Wall Template”.
Horizontal Line
Horizontal Line
Draw a horizontal line on the wall along the
bottom of the "Rear Wall Template".
Draw a vertical line on
the wall to mark the
center of the cabinet
above.
Horizontal Line
Horizontal Line
Area E
Centerline
notches
Hole A
Hole B
CAUTION: Wear gloves to avoid cutting ngers on
sharp edges.
1. Draw a horizontal line on the wall at the bottom
of the "Rear Wall Template".
2. Drill ⅝" holes for toggle bolts in 3 locations
(Hole A, Hole B, Hole C) as shown in the
illustration above. If the location of a hole lines
up with a stud, drill a
3
/
16
" hole for a wood screw.
You cannot use a toggle bolt to attach the wall
plate to a stud.
NOTE: D
O NOT MOUNT THE PLATE AT THIS TIME.
3. Holes A, B and C are inside area E. If none of
these holes line up with a stud, nd a stud in
area E that lines up with a hole circle in Area
E, and then drill a
3
/
16
" hole into it for a wood
screw. You must have at least one wood screw
mounted rmly into a stud to support the
weight of the microwave. Set the mounting
plate aside.
DE68-04108A-08_IM_ME18H704SFB_AA_EN.indd 10DE68-04108A-08_IM_ME18H704SFB_AA_EN.indd 10 2024-03-05 오전 11:50:112024-03-05 오전 11:50:11