Mini Component System Instruction Manual

GB
7
The main lead must be plugged into an appropriate socket.
Before plugging your system into a main socket, you must check
the voltage setting (OPTIONAL). If the voltage of the socket does
not correspond to the setting on the rear of the unit, you may
seriously damage your system.
Check the position of the Voltage selector on the rear of the system
(OPTIONAL).
Plug the main lead (marked AC Cord on the rear of the system) into
an appropriate socket.
Press the On/Standby button to switch your mini-compact system on.
To take full advantage of your new mini-compact system, fol-
low these installation instructions before connecting the unit.
Install the system on a flat, stable surface.
Never place this unit on carpeting.
Never place this unit in an outdoor area.
Maintain an open space of approximately 6 inches (15 cm) on the
sides and rear of the system, for ventilation purposes.
Make sure that you have enough room to open the compact disc
compartment easily.
Place the loudspeakers at a reasonable distance on either side of
the system to ensure good stereo sound.
Direct the loudspeakers towards the listening area.
For optimum performance, make sure that both speakers are placed
at an equal distance above the floor.
Where to Install Your
Mini-Compact System
Connecting your System to the
Power Supply
-- Disc Selection / Direct Play --
Volume
+
_
On/Standby
M
u
l
t
i
F
u
n
c
t
i
o
n
M
u
l
t
i
J
o
g
Disc 1 Disc 2 Disc 3
Disc Change
Demo
Timer
/Clock
Timer
On/Off
Mono/ST
REC/Pause
Down
PREV. Next
Normal
Dubbing
HI - Speed
CD
Synchro
Program
Shuffle
Return/Enter
Power
Surround
S.BASS
E Q
D.S.P
Phones
CD
Repeat
Preset/
Memory
Deck 1/2 REV.Mode
VCD/CD
AUX
TAPE
TUNER
Band
D / P / S
DIRECT PLAY & SELECTION
CD–R/RW PLAYBACK
Up
Tuning Mode
AI Sleep
MIC Mixing
Echo
MIC 1
MIC 2
MIN MAX
1
2
3
R
AUX IN
RR
L
R
VIDEO OUT
AUDIO OUT
VOLTAGE
SELECTOR
MAX-VL69GB-1~18 11/11/02 4:39 PM Page 7