User guide
Table Of Contents
- Contents
- CONNECTING AND PREPARING YOUR TV
- SETTING THE CHANNELS
- SETTING THE PICTURE
- Changing the Picture Standard
- Adjusting the Custom Picture
- Changing the Colour Tone
- Adjusting the Color Tone with the Preferred Color Component
- Resetting the Picture Settings to the Factory Defaults
- Changing the Picture Size
- Changing the Auto Wide (4:3)
- Freezing the Current Picture
- Digital Noise Reduction
- DNIe Demo (Digital Natural Image engine)
- Changing the Colour Space
- Changing the LCD 100Hz
- Viewing the Picture In Picture (PIP)
- SETTING THE SOUND
- SETTING THE TIME
- SETTING THE OTHERS
- WISELINK
- USING THE TELETEXT FEATURE
- SETTING THE PC
- RECOMMENDATIONS FOR USE
English-43
Setting the PC
Coarse and Fine Tuning of the Image (Image Lock):
The purpose of picture quality adjustment is to remove or reduce picture noise.
If the noise is not removed by Fine-tuning alone, then adjust the
frequency as best as possible (coarse) and Fine-tune again. After the noise has been
reduced, re-adjust the picture so that it is aligned on the ENTER/OK of screen.
1. Preset: Press the PC button to select PC mode.
2. Press the MENU button to display the menu.
Press the or button to select “Setup”, then press the ENTER/OK button.
3. Press the or button to select “PC”, then press the ENTER/OK button.
4. Press the ENTER/OK button to select “Image Lock”.
5. Press the or button to select “Coarse” or “Fine”, then press the
ENTER/OK button.
6. Press the or button to adjust the screen quality.
Press the ENTER/OK button.
7. Press the EXIT button to exit.
Changing the Image Position (Position):
Adjust the PC’s screen positioning if it does not fit the TV screen.
1. Follow the “Coarse and Fine Tuning of the Image (Image Lock)”
instructions number 1 to 3.
2. Press the or button to select “Position”, then press the
ENTER/OK button.
3. Press the or button to adjusting the Vertical-Position.
Press the or button to adjust the Horizontal-Position.
Press the
ENTER/OK button.
4. Press the EXIT button to exit.
Adjusting the PC Screen Automatically (Auto Adjustment):
Auto adjustment allows the PC screen of set to self-adjust to the
incoming PC video signal. The values of fine, coarse and position are adjusted
automatically.
1. Follow the “Coarse and Fine Tuning of the Image (Image Lock)”
instructions number 1 to 3.
2. Press the or button to select “Auto Adjustment”, then press the
ENTER/OK button.
3. Press the EXIT button to exit.
Initializing the Image Settings (Image Reset):
You can replace all image settings with the factory default values.
1. Follow the “Coarse and Fine Tuning of the Image (Image Lock)”
instructions number 1 to 3.
2. Press the or button to select “Image Reset”, then press the
ENTER/OK button.
3. Press the EXIT button to exit.
Press the PC button on the
remote control to select the PC
mode.
BN68-01090D-00Eng.indd 43BN68-01090D-00Eng.indd 43 2006-08-25 7:21:092006-08-25 7:21:09