User guide
Table Of Contents
- Contents
- CONNECTING AND PREPARING YOUR TV
- SETTING THE CHANNELS
- SETTING THE PICTURE
- Changing the Picture Standard
- Adjusting the Custom Picture
- Changing the Colour Tone
- Adjusting the Color Tone with the Preferred Color Component
- Resetting the Picture Settings to the Factory Defaults
- Changing the Picture Size
- Changing the Auto Wide (4:3)
- Freezing the Current Picture
- Digital Noise Reduction
- DNIe Demo (Digital Natural Image engine)
- Changing the Colour Space
- Changing the LCD 100Hz
- Viewing the Picture In Picture (PIP)
- SETTING THE SOUND
- SETTING THE TIME
- SETTING THE OTHERS
- WISELINK
- USING THE TELETEXT FEATURE
- SETTING THE PC
- RECOMMENDATIONS FOR USE
English-38
Setting Up the Remote to Operate Your DVD
1.
Turn off your DVD.
2. Press the
DVD
button on your TV’s remote control.
3. Press the SET button on your TV’s remote control.
4.
Using the number buttons on your remote control, ENTER/OK three digits of the
DVD code listed on page 40~41 of this manual for your brand of DVD.
Make sure you ENTER/OK three digits of the code, even if the first digit is a “0”.
(If there is more than one code listed, try the first one.)
5.
Press the POWER button on the remote control.
Your DVD should turn on if your remote is set up correctly.
If your DVD does not turn on after set up, repeat steps 2, 3, and 4, but try one of
the other codes listed for your brand of DVD.
If no other codes are list-ed, try each code, 000 through 141.
Note on Using Remote Control Modes: DVD
When your remote control is in “DVD” mode, the volume buttons still control your TV’s volume.
Setting Up the Remote to Operate Your STB
1.
Turn off your STB.
2. Press the
STB
button on your TV’s remote control.
3. Press the SET button on your TV’s remote control.
4.
Using the number buttons on your remote control, ENTER/OK three digits of the
STB code listed on page 41 of this manual for your brand of STB.
Make sure you ENTER/OK three digits of the code, even if the first digit is a “0”.
(If there is more than one code listed, try the first one.)
5.
Press the POWER
button on the remote control.
Your STB should turn on if your remote is set up correctly.
If your STB does not turn on after set-up, repeat steps 2, 3 and 4, but try one of
the other codes listed for your brand of STB.
(If no other codes are listed, try each code, 000 through 074.)
Note on Using Remote Control Modes: STB
When your remote control is in “STB” mode, the volume buttons still control your TV’s volume.
BN68-01090D-00Eng.indd 38BN68-01090D-00Eng.indd 38 2006-08-25 7:21:072006-08-25 7:21:07