Owner's Manual
Table Of Contents
- Before Using the Product
- Preparations
- Connecting and Using a Source Device
- Screen Setup
- Adjusting OSD (On Screen Display) settings
- Setup and Reset
- Support
- Installing the Software
- Troubleshooting Guide
- Specifications
- Appendix
28
Key Repeat Time
Control the response rate of a button when the button is pressed.
Acceleration, 1 sec, or 2 sec can be selected. If No Repeat is selected, a command responds only once
when a button is pressed.
Power LED On
Configure the settings to enable or disable the power LED located at the lower part of the product.
• Working: The power LED is on when the product is turned on.
• Stand-by: The power LED is on when the product is turned off.
HDMI-CEC
Activates or deactivates HDMI-CEC.