Owner's Manual

13
Installation
Attaching the Stand
―
Before assembling the product, place the product down on a flat and stable surface so that the screen is
facing downwards.
The product is curved. Placing pressure on the product when on a flat surface may damage the product.
When the product is on the ground facing up or down, do not put pressure on it.
1
2
3
4
Insert the stand neck into the stand base in the
direction shown in the figure.
Turn the stand neck 180° into normal position. Align the stand with the stand neck guide and
then turn the screw on the bottom of the stand
to fix the stand.
Place the protective Styrofoam (cushion)
included in the package on the floor and place
the product facing down on the Styrofoam, as
shown in the image. If Styrofoam is unavailable,
use a thick sitting mat.
5
6
Hold the main body of the product with your
hand as shown by the figure. Push the assembled
stand into the main body in the direction of the
arrow as shown in the figure.
Connect the power supply and the signal cable
as shown in the figure.