Quick Start Guide
Table Of Contents
- English
- Before Reading This Install Guide
- Warning! Important Safety Instructions
- 01 What's in the Box?
- 02 TV Installation
- 03 The Remote Control
- 04 Initial Setup
- 05 The Connection Panel
- 06 Connections
- 07 Using a TV Viewing Card (“CI or CI+ Card”)
- 08 Setting the Admin Menu
- 09 Editing Channels
- 10 Specifications and Other Information
Setting Auto Initialize
O Admin menu > Cloning > Setting Auto Initialize
When you clone settings from one TV to another, you clone both the guest side menu and hotel side menu settings:
Picture, Sound, Broadcasting, Admin menu and so on. This lets you set nearly all of the menu values on your hospitality
TVs to the same, standard settings. If you allow guests access to the guest side menus, for example the Picture menu,
they can change the settings in those menus so they are no longer standard. If you set the Setting Auto Initialize
when the TV is turned off and then turned on again. Note that Setting Auto Initialize works on cloned guest side menu
values only. Then unplug the TV's power cord, wait for the power indicator to go off, and then plug the TV's power cord in
again. Settings which have not been cloned are ignored.
The table below lists the settings that are restored to their cloned values when you set the Setting Auto Initialize
function to on.
The menu items may not be supported depending on the models.
Menu Item
Picture
Picture Mode
Fit to screen
Expert Settings
Brightness
Contrast
Sharpness
Colour
Tint (G/R)
Apply Picture Settings
Picture Clarity Settings
Picture Clarity
Judder Reduction
Noise Reduction
Contrast Enhancer
Film Mode
Colour Tone
English - 33