Quick Start Guide
Table Of Contents
- English
- Before Reading This Install Guide
- Warning! Important Safety Instructions
- 01 What's in the Box?
- 02 TV Installation
- 03 The Remote Control
- 04 Initial Setup
- 05 The Connection Panel
- 06 Connections
- 07 Using a TV Viewing Card (“CI or CI+ Card”)
- 08 Setting the Admin Menu
- 09 Editing Channels
- 10 Specifications and Other Information
06 Connections
Connecting to your Internet network
wired or wireless connection.
After you have physically connected the TV to your network, you must configure the network connection to
Admin menu
(Admin menu > Smart Service > Netwotk Setup).
Establishing a wireless Internet connection
Connect the TV to the Internet using a wireless access point or modem.
Wireless IP access point or
This TV supports the IEEE 802.11 a /b /g /n /ac communication protocols. Samsung recommends using IEEE
802.11n. Otherwise, when you play video over a network connection, the video may not play smoothly.
– Some of the IEEE 802.11 communication protocols may not be supported depending on the model or
geographical area.
To use a wireless network, the TV must be connected to a wireless access point or modem. If the wireless access
Select a channel that is not currently in use for the wireless access point. If the channel set for the wireless access
point is currently being used by another device, the result is usually interference and/or a communications failure.
Most wireless networks have an optional security system. To enable a wireless network's security system, you need
to create a security key using characters and numbers, and then enter that key into the access point through its
English - 19