Quick Start Guide
Table Of Contents
- English
- Before Reading This Install Guide
- Warning! Important Safety Instructions
- 01 What's in the Box?
- 02 TV Installation
- 03 The Remote Control
- 04 Initial Setup
- 05 The Connection Panel
- 06 Connections
- 07 Using a TV Viewing Card (“CI or CI+ Card”)
- 08 Setting the Hotel Option Menus
- 09 Using a Multi Code Remocon
- 10 Setting the Soundbar
- 11 Editing Channels
- 12 Anti-theft Kensington Lock
- 13 Specifications and Other Information
10 Setting the Soundbar
Samsung Soundbar (AirTrack) and Hospitality TVs in 2018
to the TV's sound through the Soundbar (AirTrack).
Sound bar Out in Hotel Option menu makes you control to where the TV sound is outputted when the TV is turned
on.
– Hotel Option (MUTE > 1 > 1 > 9 > SelectE) > System > Sound Bar Out
If Sound bar Out set to on, the TV sound is automatically outputted in the Soundbar (AirTrack) device only whenever
TV is turned on.
If Sound bar Out set to off, the TV sound is automatically outputted in the TV speaker only whenever TV is turned on.
Models supporting the ARC function are listed below:
–
–
Setting the Soundbar (AirTrack) to Hotel Mode
1. Set the following options in Hotel Option (MUTE > 1 > 1 > 9 > SelectE):
– System > Sound Bar Out > ON
– Power On > Power On Volume > User Defined
– Power On > Power On Volume Num > set greater than 0
– Power On > Max Volume > set greater than 0
2.
the TV.
3. After the Soundbar (AirTrack) is connected to the TV, when the TV turns on, the Soundbar (AirTrack) automatically
Soundbar (AirTrack) features in Hotel mode
Power on / off is synchronised with the TV.
Avaiable only
Acquires adjustable Power On and Max Volume settings from the TV’s Hotel Option
Power On Volume and Max Volume values are set to half of Power On Volume and Max Volume settings in the TV's
Hotel Option menu.
– If the TV's Power On Volume = 20 and Max Volume = 90, then Soundbar's Power On Volume = 10 and Max
Volume = 45.
To use Voice Guide while an external device is connected to the DIGITAL AUDIO OUT (OPTICAL) or HDMI IN (ARC)
terminal, be sure to select PCM at MENUm > Sound > Expert Settings > Digital Output Audio Format.