Quick Start Guide
Table Of Contents
- English
- Before Reading This Install Guide
- Warning! Important Safety Instructions
- 01 What's in the Box?
- 02 TV Installation
- 03 The Remote Control
- 04 Initial Setup
- 05 The Connection Panel
- 06 Connections
- 07 Using a TV Viewing Card (“CI or CI+ Card”)
- 08 Setting the Hotel Option Menus
- 09 Using a Multi Code Remocon
- 10 Setting the Soundbar
- 11 Editing Channels
- 12 Anti-theft Kensington Lock
- 13 Specifications and Other Information
Connecting the Bathroom Speakers
Connecting through the Variable Output (available without an external amplifier)
VOL+
VOL
-
TV Rear Panel
Volume Control Box
Speaker
2
1
The rear panel may differ depending on the model.
1 Connect the VARIABLE AUDIO OUT port of the TV to the Bathroom Wall Speakers of the hotel.
Speaker +
Speaker -
N/C
2 Connect the VOL-CTRL jack of the TV to the Volume Control Box Switch port on the Bathroom Wall of the hotel.
–
– The VARIABLE AUDIO OUT port supports MONO sound out only.
Installing the Volume Control
– If you configure the Volume Control Box as shown in the figure, you can control the volume of the bathroom
speakers.
–
– Volume Control Box switch is a Tact switch.
Setting the Sub AMP Mode
– 0: Turns the Sub AMP function off (PWM off).
– 1
– 2
Variable Output Port Specifications
– Speaker Wire
Volume Control Box
1)
VOL +
VOL
-
1
2
3
3)
2)