Programming instructions

LD14304-12
10. Display Quantity
The display quality of the color TFT-LCD module shall be in compliance with the Incoming Inspection Standard.
11．Handling Precautions
a) Be sure to turn off the power supply when inserting or disconnecting the cable.
b) Be sure to design the cabinet so that the module can be installed without any extra stress such as warp or twist.
c) Since the front polarizer is easily damaged, pay attention not to scratch it.
d) Wipe off water drop immediately. Long contact with water may cause discoloration or spots.
e) When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth.
f) Since the panel is made of glass, it may break or crack if dropped or bumped on hard surface. Handle with care.
g) Since CMOS LSI is used in this module, take care of static electricity and injure the human earth when handling.
h) Observe all other precautionary requirements in handling components.
i) This module has its circuitry PCBs on the rear side and should be carefully handled in order not to be stressed.
j) The polarizer surface on the panel is treated with Anti-Glare for low reflection. In case of attaching
protective board over the LCD. Be careful about the optical interface fringe etc.
Which degrades display quality.
k) Connect GND to 4 place of mounting holes to stabilize against EMI and external noise.
l) There are high voltage portions on the backlight and very dangerous. Careless touch may lead to
electrical shock. When exchange lamps or service. Turn off the power without tail.
m) Be sure not to apply tensile stress to the lamp lead cable.
n)Cold cathode fluorescent lamp in LCD panel contains a small amount of mercury, please follow local
ordinances or regulations for disposal.
12.Packing form
Piling number of cartons
5
（
Max
）
Packing quantity in one carton 20
Carton size [mm] 494(W)×326(D)×433(H)
Total mass of one carton filled
with full modules
15.6kg
05-Oct-2005