User Guide

Printed in China
QUICK
START
GUIDE
EP-H5300
Wireless Car Charger
Leaflet.0813V.1
USB Type-C cable
Contains
* Use the enclosed cable for power connection(USB car adapter is
sold separately).
Use only Samsung-approved car adapters that support 15W or higher.
* The maximum possible length of the metal hook is 35 mm.
* The indicator will turn red → green → yellow when the wireless car
charger powers on.
* Visit www.samsung.com to view the user manual and the safety
information.
RF Exposure
This equipment complies with FCC radiation exposure limits set
forth uncontrolled environment.
● Replace the clip fastener
① which is optional according to
the shape of your car's air vent(if you need).
● Set the support frame ② with proper angle to suit for your
car's air vent.
● Remove the ball joint fastener ③ from wireless car charger
by rotating it counterclockwise.
● Put the clip through the ball joint fastener, and assemble the
clip ④ on the wireless car charger.
● Rotate the control knob ⑤ to adjust the length of metal hook,
so that the wireless car charger which has been assembled
already can be locked on the air vent of car ⑥ , then connect
the USB Type C cable to the port.
● Connect the other end of the cable ⑦ to the USB-A port of a
USB car adapter* that fits into the cigarette lighter socket.
● Put the smart device close to the infrared sensor, and the
wireless car charger will open automatically ⑧ , then attach
the smart device to the wireless car charger.
● Press the quick release button ⑨ to take the smart device
off the wireless car charger.
Samsung Electronics America, Inc.
85 Challenger Road,Ridgefield Park, New Jersey 07660
Phone: 1-800-SAMSUNG (726-7864)
FCC regulatory conformance
NOTE:
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,including
interference that may cause undesired operation.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particula
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV for help.
NOTE :
The manufacturer is not responsible for any radio or TV
interference caused by unauthorized modifications to this
equipment. Such modifications could void the user’s
authority to operate the equipment.
④
Quick Guide
* USB car
adapter
⑦
⑥
- Please check the shape of the air vent and the wing length of air vent.
- Do not push or pull the wireless car charger when it has been
locked on the air vent.
- Assembly must be completed before installation on air vent.
- Before disassembly, wireless car charger must be removed
from air vent.
- Before remove the wireless car charger from the air vent, please make
sure to release the metal hook.
- Install the wireless car charger at the passenger side air vent so that
it does not only interfere with driving, but also interfere with vehicle
buttons and monitors.
- The manufacturer is not responsible for any damage to the
air vent caused by negligence in use.
Hereby, Lineprinting, declares that the radio equipment type
EP-H5300 is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at
the following internet address: www.samsung.com
The product can be used in EU countries without any restriction.
UK Regulatory Conformance
Hereby,we(Lineprinting) declared that this device is in
compliance with the essential requirements and other relevant
provisions of Radio Equipment Regulations 2017.
Manufacturer: Jiangxi Lineprinting Co.,Ltd.
Address: No.268,Nantang Road,Jinggangshan Economic
Development Zone,Ji'an City,Jiangxi,China
For information on Samsung’s environmental commitments and
product regulatory obligations, e.g. REACH, visit our sustainability
page available via www.samsung.com
Your consumer rights are governed by the law of the country in
which you purchased the product. Please contact your service
provider for more information.
This marking on the product, accessories or
literature and without the bar on batteries indicates
that the product, battery and its electronic
accessories (e.g. charger, headset, USB cable) should
not be disposed of with other household waste.
Correct disposal
AEEE Yönetmeliğine Uygundur
This product is India RoHS compliant
Ce produit est en conformité avec la directive RoHS
Samsung / PO Box 12987, Dublin. IE / Yateley,
GU46 6GG. UK
Product specification
Product name: Wireless Car Charger
Model: EP-H5300
Input: 5 V ; 2 A ; 9 V ; 1.67 A
(Support QC2.0/3.0,PD2.0/3.0,AFC Protocol)
Wireless output: Max 9W of wireless power
Charging speed may vary depending on device model and
condition of the adapter or cable.
Actual charging speed may also vary depending on the actual
usage, temperature inside/outside the vehicle, charging
conditions, and other factors.
Operating temperature: -10~40℃
IC regulatory conformance
This device complies with CAN ICES-3 (B)/NMB-3(B).
This device complies with Industry Canada licence-exempt
RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
RF Exposure
This equipment complies with IC radiation exposure limits set
forth for an uncontrolled environment.
EU regulatory conformance:
RF exposure information: The EIRP power of the device at
EN62479: 2010. RF exposure assessment has been performed
to prove that this unit will not generate the harmful EM
emission Recommendation(1999/519/EC).
Wireless Car Charger
Infrared sensor
Charging coil
(Galaxy Z Fold, S, Note)
Indicator light
Silicone pad
Quick release button
Charging coil
(Galaxy Z Flip)
Clip(with support frame) Clip fastener(Optional)
Quick start guide
Printed in China
QUICK
START
GUIDE
EP-H5300
Wireless Car Charger
Leaflet.0813V.1
Ball joint fastener
⑧
Quick release button
⑨
②
③
Optional
①
Control knob
⑤
Déclaration d’IC sur l’exposition aux radiations:
Cet équipement est conforme aux limites d’exposition aux
radiations définies par le Canada pour des environnements non
contrôlés.
Cet émetteur ne doit pas être installé au même endroit ni utilisé
avec une autre antenne ou un autre émetteur.
Le présent appareil est conforme aux CNR d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation
est autorisée aux deux conditions suivantes :
(1) l’appareil ne doit pas produire de brouillage, et
(2) l’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.