User's Manual

5
DS 24D KEYSET
Scroll
Volume
DS 24D
12ABC
3 DEF
4 GHI
5 JKL 6 MNO
7 PRS
8 TUV 9 WXYZ
0
Transfer Redial Hold Speaker
32 CHARACTER DISPLAY
Two lines with 16 characters each.
SOFT KEYS
Used to activate
features via the
display.
SCROLL KEY
Used to scroll
through displays.
8 PROGRAMMABLE KEYS WITH
TRI-COLORED LIGHTS
Keys 1-3 (1-6) are automatically
assigned as Direct Trunk keys. Key
#8 is a message key, by default.
Although all 8 keys may be
programmed for any system
features/functions.
16 PROGRAMMABLE KEYS WITH
TRI-COLORED LIGHTS
Used to call stations directly, to indicate
busy conditions of other stations, for
One Touch dialing and many other
system features.
VOLUME CONTROL KEYS
Used to set independent
levels for handset, speaker,
background music, ring
and page volumes.
MICROPHONE
For handsfree operation.
SPEAKER KEY
HOLD KEY
SPEAKER
For handsfree
operation and
ringing.
TRANSFER KEY
REDIAL KEY
iDCS_16_DS_24D.qxd 12/14/2004 3:48 PM Page 11
6
OUTSIDE CALLS
MAKING AN OUTSIDE CALL
• Lift the handset and press an idle outside line button, line group button
or dial a line access code to receive dial tone—OR—press an idle out-
side line button, line group button or dial a line access code to receive
dial tone through the speaker—OR—press SPEAKER, receive intercom
dial tone and dial a line access code.
• Dial the telephone number.
• Finish the call by replacing the handset or pressing the SPEAKER key.
NOTE: You will receive No More Calls tone when you attempt to make a call
and there is no key available for that line.
• If Least Cost Routing is enabled on your phone system, this button may
be labeled LCR or accessed by dialing an access code (usually 9).
• If your system is programmed to require an authorization code before
making a call, dial 4 plus a valid code before selecting a C.O. line.
• If your system is programmed to require an account code before mak-
ing a call, press the ACCT button or dial 47 plus a valid code, press the
ACCT button again and then select a C.O. line.
For more information on authorization and account codes, see your system
administrator.
NOTE: If the Hot Keypad feature has been turned off, you must first lift the
handset or press the SPEAKER key before dialing.
ANSWERING AN OUTSIDE CALL
• Lift the handset and you are automatically connected to the ringing call.
See Ring Preference under Customizing Your Keyset—OR—press the
SPEAKER key to automatically answer on the speakerphone.
NOTE: If a call is flashing at your keyset but not ringing, you must press the
flashing button to answer.
UNIVERSAL ANSWER
Outside lines may be programmed to ring a general alerting device. To
answer calls ringing this device, dial 67 or press the UA key. This device can
operate in the Day or Night mode.
iDCS_16_DS_24D.qxd 12/14/2004 3:48 PM Page 12