User guide

31
NOTE: Intercom calls can be automatically put on hold by pressing TRANS-
FER.
HEADSET OPERATION
Keyset users can switch between headset mode and handset mode. When
using headset mode, press the ANS/RLS key to answer and release calls.
• With the handset on-hook, press TRANSFER and then dial 110.
• Dial 21 to use the headset or 20 to use the handset.
• Press TRANSFER to store your selection.
Your keyset may be equipped with a Headset mode key. If it is so equipped
pressing this key while the light is out will cause the keyset to enter headset
mode and the light will illuminate to indicate this. Pressing the key while the
light is lit will cause the keyset to return to handset mode and the light will
go out.
HOT KEYPAD
On your phone system your keyset’s keypad can be made “live” or “hot”
so that it is not necessary to lift the handset or press the SPEAKER key
before you begin dialling. Calls can be made and features activated by sim-
ply dialling the C.O. line number, trunk group access code, intercom num-
ber or feature access code. To activate this feature:
• With the handset on-hook, press TRANSFER and then dial 110.
• Dial 31 to turn the Hot Keypad on or 30 to turn it off.
• Press TRANSFER to store your selection.
KEY CONFIRMATION TONE
You can hear a short beep (confirmation tone) each time you press a button
on the dial pad. This tone can be turned on or off.
• While on-hook, press TRANSFER and then dial 110.
• Dial 40 to turn tones off or 41 to turn tones on.
• Press TRANSFER to store your selection.
REJOINING A PAGE
This feature allows you to hear the remaining portion of an ongoing internal
page after you return your keyset to idle. To enable this feature:
• With the handset on-hook, press TRANSFER and then dial 110.
• Dial 51 to turn this feature on or 50 to turn it off.
• Press TRANSFER to store your selection.