Product specifications

4-3
SYSTEM FEATURE DESCRIPTIONS
ACCOUNT CODE ENTRY
Station users may enter an account code (maximum 12 digits) before hanging up from a call. This
account code will appear in the SMDR printout for that call record. Keyset users may enter this code
using an account code key without interrupting a conversation. Single line telephone users must
temporarily interrupt the call by hook-flashing and dialing the feature access code. Manually entered
account codes can be up to 12 digits long. In some cases users can be forced to enter an account code
and this account code may or may not be verified as described below.
Forced – Verified
When set for this option the user must enter an account code for all outgoing calls. The account code
entered will be verified from a system list of 500 entries. Forced Verified codes can contain the digits
0~9.
Forced - Not Verified
When set for this option the user must enter an account code for all outgoing calls, but the account
code is not verified against the system list. Non verified account codes can contain the digits 0~9, and
#.
Voluntary
In this case account codes are not required to make outgoing calls but may be used if desired. This is
also the method used to assign an account code to incoming calls. These account codes can contain
the digits 0~9, * and #.
ACCOUNT CODE KEY
The account code (ACCT) key can be programmed on any keyset and will appear as a soft key on
display keysets. This key allows the user to enter account codes without interrupting a call.
ALL CALL VOICE PAGE
Users can page all internal and all external paging zones at the same time by dialing the All Page code.
Keysets may be restricted from making or receiving pages in system programming. A maximum of 40
keysets can be programmed in each internal page zone to receive page announcements.
ATTENTION TONE
To get your attention, a brief tone precedes all page announcements and intercom voice calls. There
are separate programmable duration timers for page and voice announce tones.
AUTHORIZATION CODES
Authorization codes are used to give permission to make a call. A maximum of 250 four digit
authorization codes can be either forced or voluntary for iDCS 100. When used, authorization codes
will automatically change the dialing station’s class of service to the level assigned to the
authorization code. Authorization codes may be programmed to print or not print on SMDR.
FORCED
When a station is programmed for forced authorization, the user must always enter this code before
dialing is allowed. The dialed authorization code is verified from the system list of 250 authorization
codes on an iDCS 100.