User Manual(Windows 10)

Basics
41
5
Configure the IP settings.
•
When using DHCP, select Obtain an IP address
automatically.
•
When not using DHCP, contact the network administrator
for the IP address. To use a static IP address, select Use the
following IP address and set the IP address manually.
6
Select OK to save the settings.
Wake on LAN (WOL) feature
Activate the system remotely from sleep mode when a signal,
such as a magic packet command, is received via a wired LAN.
1
On the desktop, right-click the Start button ( ) and select
Control Panel
→
Network and Internet
→
Network and
Sharing Center
→
Change adapter settings.
2
Right-click Ethernet and select Properties.
3
Select Configure...
→
Power Management
→
Allow this
device to wake the computer
→
OK.
4
Restart the computer.
•
If the computer wakes up from sleep mode inadvertently,
disable the Wake on LAN feature.
•
This feature may not work while using other power saving
features. To disable other sleep functions, right-click the
Start button (
) and select Control Panel
→
Hardware
and Sound
→
Power Options.
When connected to a 100 Mbps/1 Gbps wired LAN, a
message appears informing the user of connection to
a 10 Mbps/100 Mbps wired LAN when the computer
wakes from sleep mode. This happens because restoring
the network takes about 3 seconds. When the network
is restored, the computer will be connected to the
100 Mbps/1 Gbps LAN.