Specifications

3–4

Chapter 3

Site Survey with Office DECT 8000

Tripod to hold DBS

Power cable for AC feeding

Tape measure

Map of the building

Preparation of

Preparation of Preparation of

Preparation of S

Site

ite ite

ite S

Survey

urveyurvey

urvey (Cell Planning)

(Cell Planning) (Cell Planning)

(Cell Planning)

Configure the following test environment.

To carry out the site survey, you will need to:

1. Install the BSI card in the DCS or Compact II keyphone system.

2. Connect the DBS and the BSI card using the UTP cable.

3. Connect the power cord to the keyphone system.

4. Set the DECT system parameters.

5. Register selected Office DECT 8000 handsets to the DBS.

Refer to Chapter 4,

Installation

, for full details of all these procedures.

Site Survey Procedure

Before you start cell planning, the coverage estimation for the site should be completed and the

possible DBS locations indicated on the site map. Cell planning is done as follows:

1. At a selected DBS location, set up the test configuration as shown in

Preparation of Site Survey

above.

2. Adjust the tripod to place the DBS near the ceiling or at a height of about 2.5m.

3. Press the

▼ button on the handset until you hear a short beep (after about three seconds) and

then press button “2” within one second of hearing the beep.

4. The handset displays the RSSI value of the DBS (see Figure B-1, handset LCD display [8],

shown in Appendix B).

Office DECT 8000

DBS

2.5M

Keyphone system

AC power cord

Tripod