Unit installation

6 7
ENGLISH
3. Seal the service entrance for the remote controller cable with putty
to prevent possible invasion of dew drops, water, cockroaches or
insects.
[A] For installation in the switch box
[B] For direct installation on the wall, select one of the followings:
• Prepare a hole through the wall to pass the remote controller
cable (in order to take out the remote controller cable from the
back), then seal the hole with putty.
• Take out the remote controller cable through the cut-out upper
case, then seal the cut-out notch with putty.
Wall
Remote controller
cable
Seal with putty
Conduit
Lock nut
Switch box
Bushing
[A]
Seal with putty
Remote controller cable
(To lead the remote controller cable from the back of
the controller)
Seal with putty
(To take out the remote controller cable through the
upper portion)
Remote controller cable
Wood screw
[B]
4. Connect the remote controller cable to the terminal block.
TB6 (No polarity)
To TB62 No.5 and 6 on the FTC unit
Installing the unit
Installing the remote controller
Connecting the wired remote controller cable to FTC
 Connect the wired remote controller cable to 5 and 6 on the terminal block (TB62) on the FTC controller.
• Wiring wire No.×size(mm2) : 2×0.3(polar)
• The 5m wire is attached as an accessory. Max. 500 m
• Wiring size must comply with the applicable local and national codes.
• Circuit rating : DC12V
Circuit rating is NOT always against the ground.
NOTE
Installing the wired remote controller
1. Select an installing position for the remote controller.
Required clearances surrounding
the remote controller
Installation pitch
Remote controller profile
30
83.5
120
30
46
30
2. Procure the following parts locally :
• 2 piece switch box
• Thin copper conduit tube
• Lock nuts and bushings