User Manual

E-13
In the Automatic mode, the room temperature and the fan speed are
controlled automatically.
1
To select the AUTO mode, press the Mode button until is displayed
at the top of the wired remote controller.
Result:
: ◆ The air conditioner runs in AUTO mode.
2
You can change modes at any time.
If necessary, press (ON/OFF) button.
Result:
: ◆ The On/Off indicator on the wired remote controller comes on.
◆ The air conditioner runs in the mode selected when
◆ the unit was last used.
The air conditioner is fitted with a protection mechanism to
prevent the unit from being damaged when it is started
immediately after being:
◆ Plugged in
◆ Stopped
lt will start up normally after three minutes.
IMPORTANT
N
N
o
o
t
t
e
e
Selecting the Automatic Operating Mode
To adjust the temperature, press the Temperature buttons one or more times
until the required temperature is displayed. Possible temperatures are between
18
O
C and 30
O
C inclusive.
Result:
◆ Each time you press Temperature buttons:
- The temperature is adjusted by 1
O
C.
◆ The air conditioner takes the present temperature of the room
every 30 minutes.
- If the temperature is higher than the selected temperature +
α,
the air conditioner will start cooling.
- If the temperature is lower than the selected temperature -α, the
air conditioner will start heating.
3
The α is a preset temperature for the most comfortable environ-
ment. It can be adjusted by your installation specialist when
installing the product.
N
N
o
o
t
t
e
e
ENGLISH