User manual

cleaning & care_29
DOOR REMOVAL
For normal use, the oven door must not be removed but if removal is necessary, for example, for
cleaning purposes, follow these instructions.
CAUTION: The oven door is heavy.
70
2
1
1. Open the door and
flip open the clips
at both hinges
completely.
2. Close the door by approximately
70 °. With both hands, grasp
the sides of the oven door at
its middle and pull-lift until the
hinges can be taken out.
3. After cleaning, for
attaching the door repeat
the 1 and 2 steps in revers
order. The clip on the
hinge should be closed on
both side.
DOOR GLASS REMOVAL
The oven door is equipped with 3 sheets of glass placed against each other. These sheets can be
removed for cleaning.
WARNING: The oven door must be removed from the oven for cleaning the door glasses.
Glass 1
2 Guide
rubbers
Glass 1
Glass 2
Guide rubbers (Right and Left)
Cover
1. Remove 2 screws
on the left and
right sides of the
door.
2. Detach the cover and
remove glass 1, 2 and
2 guide rubbers from
the door.
3. After cleaning the door glasses, for
assembly repeat 1, 2 steps in revers
order. Check the right locations of
glasses with above picture.
The quantity of door glass is dierent from 3 EA to 4 EA model by model.
Important: When assembly the inner glass 1, make sure not to use glass 2 and put printing
to direction below.
WATER COLLECTOR CLEANING
The water collector is for collecting the water from the moisture
when oven is operating with very moist food. Food waste can be
stack on the water collector. If the cleaning is not performed, the
built-in furniture can be damaged. Clean the water collector to
protect your furniture after cooking.
WARNING: If you encounter a water leakage from the water
collector after the cooking, please contact us at the service
center.
Water collector
CLEANING & CARE
BQ1VQ6T012_XSA_DG68-00382U-03.indd 29 7/5/2013 8:00:38 PM