دليل المستخدم

Heating Your Room
E-9
HSILGNE
You must select the Heat mode if you wish to heat your room to a specific
temperatu
re. You can also set the fan speed.
1 If necessary, press the (On/Off) button.
Result
: ◆ The operating mode indicator (COOL, FAN or HEAT) on
the
unit comes on.
◆ The air conditioner starts up in the mode selected
when
the unit was last used.
◆ The unit beeps twice.
☛
The air conditioner is fitted with a protection mechanism to prevent
the
unit from being damaged when it is started immediately after
being:
◆ Plugged in
◆ Stopped
It
will start up automatically after about three minutes.
2 If the HEAT indicator is not lit up on the unit:
◆ Press the button on the remote control
or
◆ Press the MODE button on the unit one or more times until the HEAT
indicator
lights up
Result
: ◆ The unit beeps each time you press MODE.
◆ The air conditioner starts up in Heat mode.
➢
You can change modes at any time.
3 To adjust the temperature, press the or button on the remote
control
one or more times until the required temperature is displayed.
To adjust the temperature, press the or button on the unit one
or
more times until the required temperature is displayed.
Possible
temperatures are between 16°C and 30°C inclusive.
Result
: ◆ Each time you press the temperature buttons:
– The temperature is adjusted by 1°C and
displayed
on the control panel
– The unit beeps
◆ The air conditioner starts heating if the room temperature is
lower
than the selected temperature.
4 To set the fan speed to...
Then..
.
Result: Each time you press a button, the unit beeps.
5 To control the direction of the air flow, refer to page 11.
High ◆ Press the button on the remote control.
or
◆ Press the on the unit until the
indica
tor lights up
Med ◆ Press the button on the remote control.
or
◆ Press the on the unit until the
indica
tor lights up
Low
◆ Press the button on the remote control.
or
◆ Press the on the unit until the
indica
tor lights up
Remote Control
Control
Panel