دليل المستخدم

2 Remove the screw located at the lower section of the front grille.
It is secured in the section depending on the mode
l
.
E- 20
Rubber cap
Screws(2EA)
Gasket
Rear
Drain Tube
Installation of the Drain Tube
Fix the
drain tube as shown in the figure.
Installation of the Drain Pan
The procedure
for installing the drain pan should be determined by the
condition of the installing are
a.
1 Open the front
grille; refer to page 15.
3 Re
move the front panel.
4 Re
move two screws on the lower, right and left sides of the unit.
Exampl
e
: High storage
In the case of an area where the drain pan can not be directl
y
installed on the rear side of the unit after installing the air condition
er.
3-1 Press both sides of the cabinet in the directionof the arrow
as s
hown in the figure.
3-2 Pull the
lower part of the front panel slightly forward.
(be
low three inches)
3-3 Lift the front panel u
pward.
Applying excessive force to remove the front panel
may cause damage to the tab; be sure not to use
excessive force.
In some region, drain tube and drain pan may not be supplied.
Plesae contact the sales a
gent.
5 Remove the chassis from the cabinet.
6 Re
move the rubber cap inserted into the basepan.
7 Fix the
drain pan as shown in the figure, and then connect the drain hose.
(You can use any commercially-available drain hose.)
8 Install the cabinet at the specified area after installing the
drain pan,
and then re-asse
mble it in the original condition.
1 Follow steps 6 and 7 only
In the case of an area where the drain pan can be direc
tly installed
on the rear side of the unit after installing the air condition
er.
Secure the front panel to the case by replacing the screw removed in
step
2. If a screw not removed in setp 2, secure the panel with a
supplied sc
rew.
Rear
Screw
Drain Pan
Rubber cap
Drain Hose
Bottom-Side View with
Drain Pan and Hose in Place