User manual

24_ installing
installing your air conditioner
GETTING READY TO INSTALL THE AIR CONDITIONER
First select a room and check conditions prior to installation.
Checking included parts
Check that all necessary parts are included. Actual accessories may slightly differ from the
illustration shown below.
Gasket Draintube Rubbercap Screws
Selecting the best location
The unit should be level when installed, so that the drainage system and other mechanisms
operate efficiently. If possible, install the unit in a shaded area on the home’s north or east side.
Before installation, select a location that fulfills these requirements:
• easy access to control panel.
• away from direct exposure to sunlight.
• adequate ventilation.
• can easily connect to a power source.
• can support the weight of the air conditioner and will not cause increased operating noise
and vibration.
• where there is no obstacles near the air inlet and outlet.
• the bottom of the unit clears at least 750 mm above ground level.
Power
500mm 500mm
750mm
75mm
min.
300mm
500mm
about 3˚
150mm min.
awning
If the wall is thicker than 150mm,
cut the back of the wall at 45°.
100mm or more
Outdoor side
Indoor side
45˚ 45˚
OutdoorsideIndoorside
<Fence, wall
or other
obstacles>
“A”
MODE “A”
AW18
 260mm
H3 project F_DB98-33004A-E_10.12.06.indd 24 2011-2-9 14:14:39