USER'S MANUAL AW12P0 Series Window-type Room Air Conditioner (Cooling) E S DB98-29901A
Register your product at www.samsung.com/global/register Safety Precautions The following safety precautions must be taken when using your air conditioner. Risk of electric shock. • Can cause injury or death. • Disconnect all remote electric power supplies before servicing, installing or cleaning. • This must be done by the manufacturer or its service agent or a similar qualified person in order to avoid a hazard.
Contents PREPARING YOUR AIR CONDITIONER n Safety Precautions......................................................................................... 2 n Air Conditioning Unit-Main Parts and Control Panel...................................... OPERATION YOUR AIR CONDITIONER n n n n n 4 Cooling Your Room........................................................................................ 5 Airing Your Room..........................................................................................
Air Conditioning Unit - Main Parts and Control Panel The design and shape are subject to change according to the model. Air Outlet Inner air flow blades (right/left orientation) Air inlet (Inside) Outer air flow blades (up/down orientation) The air filter is located in side Air inlet (Outside) Ventilation lever Power Cable The type of the power plug may differ according to the type of local power supply.
Cooling Your Room You must select the Cool mode if you wish to lower the temperature in your room.You can also set the fan speed. 1 Select the operating mode and fan speed. To cool your room with a... Set the operating mode selection dial to... High fan speed HI COOL Between HIGH and LOW MED COOL Low fan speed LOW COOL Result: The air conditioner starts up in the Cool mode. The fan starts up at the speed selected. You can change modes at any time.
Airing Your Room If the atmosphere in your room is stale, you can air it using the Fan feature and if necessary, evacuate the stale air outside. 1 If you wish to evacuate stale air outside, push the ventilation lever on the front of the unit to the right and the open position ( Result: ). The air inside the room circulates and stale air is evacuated outside. Otherwise, push the ventilation lever to the left and the closed position ( Result: 2 The air simply circulates inside the room.
Adjusting the Air Flow Direction Horizontally Depending on the position of the unit in your room, you can adjust the orientation of the inner air flow blades on the unit, thus increasing the efficiency of the air conditioner. 1 Adjust the air flow blades to the desired position by sliding them side to side. Adjusting the Air Flow Direction Vertically Again depending on the position of the unit in your room, you can adjust the orientation of the outer air flow blades on the right-hand side of the unit.
Cleaning Your Air Conditioner Be sure to clean the air filter periodically to maintain the air conditioner in the best condition for a long period of time. IMPORTANT When cleaning the air conditioner, turn it off and pull out the power plug. 1 Hold the front grille handle, slightly pull it to the left side and open the front grille. The removal of the front grille makes it easier to clean the air conditioner. Open the grille as much as possible.
Solving Common Problems Before contacting the after-sales service,perform the following simple checks. They may save you the time and expense of an unnecessary service call. Problem Explanation/Solution The air conditioner does not Check that the circuit breaker used for the air conditioner has not operate at all been triggered. Check that the power cable is plugged into a wall socket and the socket is switched on, if necessary.
Installation (for 60Hz) 1 Electrical Requirements For personal safety: This appliance must be properly grounded. Do not, under any circumstances, cut or remove the third grounding prong from the power cord. We recommend that you do not use an extension cord or an adapter plug with this appliance. Do not change the plug on the power cord of this appliance. Follow national electrical codes or local codes and ordinances.
Installation Before installation, be sure to check the installation area or the air conditioner, and drain hose. Checkpoints prior to installation 1 Check the cabinet and front grille of the unit for any harmful defects such as scratches. 2 Be sure to check the power supply. - Refer to the specifications on the label attached to the unit.
Installation(cont.) Rear Rubber cap Screws(2EA) E-12 Gasket Drain Tube Installation of the Drain Tube Fix the drain tube as shown in the figure.
Memo E-13
